setting up your side-by-side refrigerator
SETTING UP THE REFRIGERATOR(CONT’D)
If your entrance won’t allow the refrigerator to pass easily through it, you can remove the doors.
Tools you will need
Philips Screwdriver | 10mm Socket Wrench |
Removing the Front Leg Cover
First, open both the freezer and refrigerator doors, and then take off the front leg cover by turning the three screws
FRONT LEG COVER
SCREW
Separating the Water Supply Line from the Refrigerator
1.Remove two water lines(gray one is for ice and the other one is for water)by pressing the coupler
1 and pulling the water line 2 away.
1
| Make sure the color of the |
2 | water lines match. |
Reattaching the Water Supply Line
1.The Water Line must be fully inserted to the marked line to prevent water leakage from the dispenser.
2.Insert the 2 clips in the install pack
and check that each clip holds the line firmly. These clips are for door
Line
Coupler
clip A (¼”) (6.35mm)
Coupler
Line
Coupler
clip A (¼”) (6.35mm)
Coupler
The water line must be fully inserted to the marked line to prevent water leakage from the dispenser.