Samsung RFG297HD, RFG29PHD Controlling the Temperature, Controlling the Freezer temperature

•The locked symbol should be lined up with the indicator line.

4

5.Touch the "Alarm/hold 3 sec for Filter Reset" button

( (Filter Reset) ) for about 3 seconds to reset the water fi lter. The color of

indicator ( ) changes from red to blue, green, or yellow.

6.If you turned off the water supply, turn it back on.

For a replacement water fi lter, you can visit your local home Improvement center or contact

the Samsung Parts distributor. Be sure the replacement water fi lter has the SAMSUNG logo on the box and on the water fi lter.

Link : http://www.samsungparts.com

Removing any residual matter inside the water supply line after installing the water filter.

1.Turn ON the main water supply and supply water from water supply line.

2.Run water through the dispenser until the water runs clear (approx. 6 to 7 minutes). This will clean the water supply system and remove air from the lines.

3.Additional fl ushing may be required in some households.

4. Open the Refrigerator door and make sure there are no water leaks coming from the water

fi lter.

Be sure to fl ush the dispenser thoroughly, otherwise water may drip from the dispenser. This means that there is still air in the line.

Reverse Osmosis Water Supply IMPORTANT:

The pressure of the water supply coming out of a reverse osmosis system going to the water inlet valve of the refrigerator needs to be between 35 and 120 psi (241 and 827 kPa).

If a reverse osmosis water fi ltration system is connected to your cold water supply, the water pressure to the reverse osmosis system needs to be a

minimum of 40 to 60 psi (276 to 414 kPa.)

If the water pressure to the reverse osmosis system is less than 40 to 60 psi (276 to 414 kPa):

• Check to see whether the sediment fi lter in the reverse osmosis system is blocked. Replace the fi lter if necessary.

• Allow the storage tank on the reverse osmosis system to refi ll after heavy usage.

• If your refrigerator has a water fi lter, it may further

reduce the water pressure when used in conjunction
with a reverse osmosis system. Remove the water fi lter.	02
If you have questions about your water pressure, call
	OPERATING
a licensed, qualifi ed plumber.

CONTROLLING THE TEMPERATURE

Basic temperature of Freezer and

Refrigerator Compartments

The basic temperature and recommended temperatures of the Freezer and Refrigerator Compartments are -2°F and 38°F (or -19°C and 3°C) respectively. If the temperature of the Freezer and Refrigerator Compartments are too high or low, adjust the temperature manually.

Controlling the Freezer temperature

Recommend Temp (Freezer) : -2°F (or -19°C )

The Freezer temperature can be set between -8°F and 8°F (or between -22°C and -14°C) to suit your particular needs. Press the Freezer button repeatedly until the desired temperature is shown in the temperature display. The temperature will change by 2°F (or 1°C) with each press. See below.

Fahrenheit : -2°F ➞ -4°F ➞ -6°F ➞ -8°F ➞ 8°F ➞ 6°F

➞4°F ➞ 2°F ➞ 0°F ➞ -2°F.

Centigrade : -19°C ➞ -20°C ➞ -21°C ➞ -22°C ➞

-14°C ➞ -15°C ➞ -16°C ➞ -17°C ➞ -18°C ➞ -19°C. Keep in mind that foods like ice cream may melt

at 4°F (or 0°C). The temperature display will move sequentially from -8°F to 8°F (or from -22°C to -14°C).

operating _13