| Changing the door hinges |
7.3 | 8.1 Remove soft stop mechanism (top) |
1061) |
|
(1) | Overlay panel | (3) | Fig. 23 |
Backer panel | |||
(2) | Spacer panel | (4) | Glassed area |
The edges of the panels Fig. 23 (1,2,3) are visible at the transition to the glass window Fig. 23 (4). It can be covered with a decorative molding Fig. 24 (A) for esthetic reasons.
Fig. 24
8 Changing the door hinges
You can reverse the door hinges, if necessary: Make sure you have the following tools on hand: q Torx 25
q Torx 15
qScrewdriver
qCordless screwdriver, if necessary
qAnother person to help with the installation, if necessary
Fig. 25
u Open the door.
NOTICE
Risk of damage!
If the door seal is damaged the door may not close properly and the level of cooling is insufficient.
u Do not damage the door seal with the screwdriver!
u Release panel Fig. 25 (1) using slotted screwdriver and remove.
w The panel hangs above the damper bracket.
Fig. 26 u Push panel forward over the damper bracket Fig. 26 (4)
in the direction of the appliance.
WARNING
Risk of injury if the soft stop mechanism contracts!
If the locking device is not fitted, the soft stop mechanism contracts during disassembly and can jam your fingers.
uFit the locking device!
uEngage locking device Fig. 26 (2) into place inside oblong hole.
The locking device prevents the hinge from snapping shut.
Unscrew cover that is on the hinge side Fig. 26 (5) until the first notch using a screwdriver.
The bolt will become visible.
Push bolt Fig. 26 (3) out from below.
Press damper bracket Fig. 26 (4) in the direction of the
door.wuwuu
19