Liebherr RI 1410/ RBI 1410/ FI 1051 manual Cabinet Opening Dimensions

Page 7

Cabinet Opening Dimensions

4 Cabinet Opening Dimensions

	Fig. 7 Side-by-side installation:
	The door must be able to be opened at least 90° to allow
	the drawers to be pulled out properly. If the door opening
	angle is 90° it may be difficult to remove the drawers due
	to the door racks.
	If the appliance will be installed in a corner please leave a
	gap of at least 3-3/4 in. (95 mm) from the wall.
Fig. 6 Single installation	If thick front panels are used, the gap may have to be
Fig. 6 Single installation	greater. (see chapter on décor panels)

5 Air circulation in the kitchen cabinet

This is a built-in refrigerator-freezer with custom finished door panels.

The unit is not intended for freestanding use and has to be installed inside a cabinet. This type of cabinet must be carefully constructed using the proper dimensions and it must provide proper ventilation to ensure proper appliance operation.

7

Image 7

Contents Installation Instructions General safety information General safety information ContentsSetting up the appliance Setting up the appliance Planning information Single-unit installationSide-by-side installation SBS24I3, SBS24I1, SBS24I6 Planning information Air circulation in the kitchen cabinet Cabinet Opening DimensionsAir outlet Door swing clearance110, hinges on left 90, hinges on left 110, hinges on right 90, hinges on right Fitting décor panels Fitting décor panelsDécor panel dimensions Framed panels Thickness of panel Overlay Panel Backer Panel Spacer PanelOverlay panel Spacer panel Backer panel Width W Height HFront view Side-by-side installationOverlay panel Spacer panel Backer panel Spacer Overlay panel Backer panel Spacer panel Glassed area Changing the door hingesCut-out for glass window WFI 1061Remove door Remove soft stop unit bottomSwapping bearing parts Swapping the clip-on frameFitting the door Loosen cover 9 from the panel 1 Fit opening limiter Adjusting the door opening angleAligning the door Removing the soft stop unit u Open the doorWater connection Fit side installation strip Single unit installationAnti-tip device Fit upper ventilation grille Install end stripSecure side installation strips Install the appliance in the recessFit handles overlay panel Fit décor panels see Fit handles framed panelFit side installation strips Side-by-side installationJoin appliances Fit upper ventilation grille 80 or Fit end strip Secure side installation stripFit handles to the overlay panel 63as shown in the diagram Connecting the appliance Installing the water filterConnecting the appliance