Single unit installation
Fig. 48
u Fit retaining plate Fig. 48 (1) to the lower part of the handle side by inserting two screws Fig. 48 (2) into the
u Slide installation strip Fig. 48 (3) into the retaining plate Fig. 48 (1) from above.
u Push second retaining plate Fig. 48 (4) onto the installation strip Fig. 48 (3) from above and screw to the center of the side wall.
u Push third retaining plate Fig. 48 (4) onto the installation strip Fig. 48 (3) from above and screw to the top part of the side wall.
Note
u Depending on the recess height you will need to install a ventilation grille or an end strip. Observe the necessary ventilation
Fit upper ventilation grille (80”):
Fig. 49
u Open the door.
u Position ventilation grille Fig. 49 (10) over the installation contour Fig. 49 (5) and align it such that the holes in ventilation grille and installation contour are above each other.
u Screw ventilation grille Fig. 49 (10) to installation contour Fig. 49 (5)from below using three screws Fig. 49 (11).
Install end strip:
Fig. 50
u Open the door.
u Position end strip Fig. 50 (10) over the installation contour Fig. 50 (5) and align it such that the holes in ventilation grille and installation contour are above each other.
u Screw end strip Fig. 50 (10) to installation contour Fig. 50 (5)from below using three screws Fig. 50 (11).
Secure side installation strips:
carry out the following steps for the
Fig. 51
u Remove adhesive tape from the side installation strip Fig. 51 (3).
u Push installation strip Fig. 51 (3) upwards until it is touching the ventilation grille Fig. 51 (10).
u Glue the adhesive plates Fig. 51 (20) above the retaining plate Fig. 48 (1) and the retaining plates Fig. 51 (4) respectively to the installation strip Fig. 51 (3) such that it cannot slide downwards.
Install the appliance in the recess:
u Connect appliance to the water supply (see 10) .* u Insert the power cable into the socket (see 15) .
26