Setting up the appliance
Verify that:
q The floor under the appliance is flat and level.
q The floor can support the appliance's weight plus approximately 1200 pounds (544 kg) of food weight.
q The appliance is not placed in direct sunlight or near the stove, range top, radiators and similar heat sources. q The kitchen cabinet that the appliance is installed in is shimmed to the floor level if the floor heights are not
equal.
q Cutout dimensions are accurate.
q Electrical outlet is in correct location.
q The air flow is not restricted. Air flow must be provided for the appliance to operate properly. The factory air vents provide 31 square inches (200 cm2) of air flow per appliance. If you are replacing the air vents with an overlay, the air flow must be the same or greater than the factory air vents.
u Examine the unit and packaging for shipping damage. Contact the carrier immediately if you suspect there is any damage.
u Note the type (model, number), index, appliance/serial number, date of purchase and where purchased .
u Remove anything attached to the rear or side walls of appliance that would prevent proper installation or impede proper ventilation.
If the appliance is set up in humid areas, condensation may build on the outside of the appliance.
u Always ensure proper ventilation.
3