Liebherr RI 1410/ RBI 1410/ FI 1051 manual Anti-tip device, Single unit installation

Anti-tip device

NOTICE

Risk of thread damage! u Do not overtighten.

u Connect the domestic water supply Fig. 43 (5) (e.g. copper pipe) to the elbow connector Fig. 43 (4).

Before fitting into the cabinet:

u Check the whole water system for leaks. Before using for the first time:

u Have the water line bled (remove air) by a competent professional.

NOTICE

Malfunction of the water intake!

If the water intake is shut off during operation but the IceMaker remains in operation, the water intake pipe may ice up.

u Switch off the IceMaker if the water supply is interrupted (e.g. holiday).

11 Anti-tip device

The screws for fastening the anti-tip device are not supplied with the appliance. Appropriate screws must be used for the material (wood, concrete, etc.) in which the safety device is mounted.

WARNING

Risk of injury if the appliance tips over!

u Install the anti-tip device to prevent the appliance from tipping over when the fully loaded door is open.

Fig. 45

The accessories kit 9900302 may be required depending on the height of the recess. (see 4)

Fig. 44 u Mark the installation position for the anti-tip device on

the wall or back of the unit.

u Install the anti-tip device Fig. 44 (1) using appropriate screws Fig. 44 (2).

12 Single unit installation

Kit 9900306 is required for the installation.

Fig. 46

u Install anti-tipping device inside the recess (see 11) .

Fig. 47

u Screw on upper installation contour Fig. 47 (5) through the pre-cut holes using four screws Fig. 47 (6).

Fit side installation strip:

25