Toshiba RAV-SM1401AT-E Requirement, Installation of ceiling panel Sold separately, RAV-SP1100UT-E

RAV-SP1100UT-E,

RAV-SM560UT-E, RAV-SM800UT-E, RAV-SM1100UT-E, RAV-SM1400UT-E

REQUIREMENT

Before installation of the indoor unit, be sure to remove the cushion for transportation between the fan and the bell mouth. Running the unit without removing the cushion may damage the fan motor.

Be sure to remove the cushion for transportation between the fan and the bell mouth.

Installation of ceiling panel (Sold separately)

Install the ceiling panel according to Installation Manual attached with it after piping/wiring work has completed.

Check that installation of indoor unit and ceiling opening part is correct, and then install it.

REQUIREMENT

Joint the connecting sections of ceiling panel, ceiling surface, ceiling panel and indoor unit closely.

Any gap between them will cause air leakage and this generate condensation or water leakage.

Installation of remote controller (Sold separately)

For installation of the wired remote controller, follow the Installation Manual attached with the remote controller.

•Pull out the remote controller cord together with the refrigerant pipe or drain pipe.

Be sure to pass the remote controller cord through upper side of the refrigerant pipe and drain pipe.

•Do not leave the remote controller at a place exposed to the direct sunlight and near a stove.

•Operate the remote controller, confirm that the indoor unit receives a signal surely, and then install it. (Wireless type)

•Keep 1m or more from the devices such as television, stereo, etc.

(Disturbance of image or noise may generate.) (Wireless type)

– 81 –