Toshiba RAV-SM561AT-E, RAV-SM1101AT-E, RAV-SM1401AT-E, RAV-SM801AT-E installation manual Maintenance

RAV-SP1100UT-E,

RAV-SM560UT-E, RAV-SM800UT-E, RAV-SM1100UT-E, RAV-SM1400UT-E

8 MAINTENANCE

Before maintenance, be sure to turn off the leakage breaker.

Cleaning of air filter

• If is displayed on the remote controller, maintain the air filter.

• Clogging of the air filter reduce cooling/heating performance.

Cleaning of panel and air filter		Suction grille
Preparation :
1.	Turn off the air conditioner by the remote controller.
2.	Open the suction air port.	Button

•Slide the button of the suction air port inward, and open the suction port slowly while holding it.

Clean the panel and air filter with water:

• Wipe down the panel and air filter with a sponge or towel moistened with a kitchen detergent. (Do not use any metallic brush for cleaning.)

•	Carefully rinse the panel and air filter to wash out the detergent.
•	After rinsing the panel and air filter with water, dry it in the shade.	Suction grille
3. Close the suction air port.
	• Close the suction air port, slide the button outward, and fix the
	suction port securely.	Button

CAUTION

• Do not start the air conditioner while leaving the panel and air filter removed.

• Push the filter reset button. ( indication will be turn off.)

Cleaning of Air Filters

•If the air filters are not cleaned, it not only reduce the cooling a performance of air conditioner but causes a failure in the air conditioner such as water falling in drops.

Preparation :

Strap to prevent falling

Push

1.	Stop the operation by remote controller.	Air filter
2.	Dismount the air filter.

Use a vacuum cleaner to remove dust from the filters or wash them with water.

•After rinsing the air filters with water, dry them in the shade.

•Set the air filter into the air conditioner.

Cleaning of discharge flap

The discharge flap can be removed to clean.

1. Remove the discharge flap.

•Holding the both ends of the discharge flap, remove the flap sagging the center downward.

2. Cleaning with water 1 Insert

• If the dirt is terrible, clean the flap by tepid water with neutral detergent or water.

3. Mount the discharge flap.

• First push in one side of the flap, and then insert the other side sagging the center downward.

Be careful to the direction of the flap when mounting.

2Insert in the flap sagging down the center downward.

Mount the flap so that the side with the mark faces upward and the arrow direction of the mark directs.

– 91 –