Toshiba RAV-SM801AT-E Electrical Work, Remote controller cabling, Cabling diagram

RAV-SM561BT-E, RAV-SM801BT-E, RAV-SM1101BT-E, RAV-SM1401BT-E

7 ELECTRICAL WORK

Cabling

1.As shown in the figure, remove a screw • and then remove cover of the electric part.

2.Strip wire ends (10 mm).

3.Match wire colors with terminal numbers on indoor and outdoor units’ terminal blocks and firmly screw wires to the corresponding terminals.

4.Connect the ground wires to the corresponding terminals.

5.Fix the cable with cord clamp.

6.Fix cover of the parts box and the terminal block surely with the fixing screws.

Make a loop for the margin of the cable length so that the electric parts box can be taken out during servicing.

10	1	2	3
			10
50			30

Earth line

Connecting	C
cable	B
	A

Electric parts box

Connecting cable hole

Electric parts box cover

Remote controller cabling

•Strip approx. 14mm the cable to be connected.

•Non polarity, 2 core cable is used for cabling of the remote controller.

•Twist cable of the remote controller to be connected with cable of the remote controller unit (or sensor), and press- fit them with a wire joint. (Wire joints (White: 2 pieces) are included in the attachments to the remote controller (sold separately) or the wireless remote controller kit (sold separately).

				Approx. 200mm		W : White
Remote controller cabling						B : Black
	Terminal block		A	W		Remote controller
	for remote controller		B	B		unit or sensor part
	cabling of indoor unit
Cable from remote	Wire joint
controller unit		Remote controller cable		Connecting	Remote controller unit or
		(Procured locally)		part	cable from sensor part

Cabling diagram

•For details of cabling/installation of the remote controller, refer to the Installation Manual attached to the remote controller.

•When the remote controller is used for the first time, it accepts an operation approx. 5 minutes after the power supply has been turned on. It is not a trouble, but is because the setup of the remote controller is being checked. For the second power-ON time and after, approx. 1 minute is required to start the operation by the remote controller.

– 110 –