Adjusting the door opening angle
u Remove locking device Fig. 37 (2) by twisting it. u Snap panel Fig. 37 (1) into place on the door.
u Turn cover Fig. 27 (6) 180° from the handle side, place it on top from the outside and snap into place.
8.9 Aligning the door
u Unscrew center screw on lower part of bearing bracket Fig. 32 (20).
u Align the doors flush with the appliance housing using the two oblong holes in the lower bearing bracket Fig. 32 (20) as a guide if needed.
u Tighten the screws fully.
9 Adjusting the door opening angle
The appliance is delivered with a door opening angle of 110°. If the angle needs to be limited to 90° an opening limiter must be used on the soft stop mechanism. Carry out the following steps for all soft stop mechanisms on the appliance (the top soft stop mechanism is illustrated):
Removing the soft stop unit u Open the door.
u Unscrew spacer Fig. 39 (10) .
u Push panel forward over the damper bracket Fig. 39 (4) in the direction of the appliance.
u Engage locking device Fig. 39 (2) into place inside oblong hole.
w The locking device prevents the hinge from snapping shut.
u Unscrew cover that is on the hinge side Fig. 39 (5) until the first notch using a screwdriver.
w The bolt will become visible.
u Push bolt Fig. 39 (3) out from below.
u Press damper bracket Fig. 39 (4) in the direction of the door.
u Completely loosen cover that is on the hinge side Fig. 39 (5) and remove.
u Remove panel Fig. 39 (1).
u Unscrew soft stop unit (2 x Torx 15) Fig. 39 (6).
u Slightly pull out soft stop unit, push it towards the handle side and open it out.
Fit opening limiter:
Fig. 38
NOTICE
Risk of damage!
If the door seal is damaged the door may not close properly and the level of cooling is insufficient.
u Do not damage the door seal with the screwdriver!
u Release panel Fig. 38 (1) using slotted screwdriver and remove.
w The panel hangs above the damper bracket.
Fig. 40 u Fit opening limiter (90°) Fig. 40 (21) supplied: insert it into the soft stop mechanism from the side and push in
until it audibly snaps into place.
Re-attaching the soft stop mechanism:
23