Liebherr BF/BFI 1051 Operation, Turning the Appliance on, Setting the Temperature Figure

OPERATION

(From Figure 1)

Turning the Appliance ON and

OFF - Figure 1

Clean the appliance before turning it on for the first time. See Cleaning.

Allow the appliance to operate approximately two hours before placing food in it. DO NOT place frozen food in the freezer until the temperature shows at least 0°F (-18°C). The refrigerator and freezer compartments can be operated separately.

Pressing the appliance main ON/OFF switch (Fig. 1, 3) always turns the entire appliance, both the BioFresh and the freezer compartment, ON or OFF.

1.Turning ON:

Press the BioFresh ON/OFF button (Fig. 1, 9) and the Freezer ON/OFF button (Fig. 1, 3), the Temperature Displays (Fig. 1, 1) and (Fig. 1, 7) light up or "flash".

•The interior light will turn ON when the refrigerator door is open.

•The freezer compartment display will display lines until a temperature less than 32°F (0°C) is reached.

2.Turning OFF: Press the Refrigerator ON/OFF button and the Freezer ON/OFF button for about one second so the temperature displays go out.

If you only want to turn OFF the BioFresh compartment, and leave the freezer compartment ON, press ON/OFF button (Fig. 1, 9). This is very useful during vacation periods or when using the freezer only. The BioFresh temperature display (Fig. 1, 7) and the interior light will go out. The freezer temperature (Fig. 1, 1) will display.

Setting the Temperature - Figure 1

The appliance is pre-set for normal operation. We recommend temperatures of 34°F (+1 °C) in the BioFresh compartment and 0°F (-18 °C) for the freezer.

To reduce the temperature:

Press the ￿ (DOWN) button; (8) on left for BioFresh compartment and (2) on right for the freezer compartment.

To increase the temperature:

Press the ￿ (UP) to increase temperature (Fig. A1, 2 or 8).

The temperature in the BioFresh compartment is controlled automatically, between 32°F to 36°F (0°C and 2°C). If you want a higher or lower temperature, for example, for storing fish, you can alter the temperature setting in the BioFresh compartment. The setting range is displayed as between b1 and b9. The default factory setting is b5.

The temperature can be changed by ± 5 increments, displayed in the temperature display.

Note

By decreasing the temperature, b4 to b1, minus temperatures can be reached and the food will freeze slightly.

For the freezer compartment, the setting range is displayed between 8°F and -14°F (-13°C and - 26°C). Whether you can obtain the lowest freezer temperature depends on where the appliance is positioned (if it is located in an area with a high ambient temperature it will not reach the lowest temperature).

While you are entering the temperature, the set temperature will flash on the display.

When you press the temperature setting buttons for the first time, the most recent setting is displayed.

You can change the settings in increments by briefly pressing the buttons again. If the buttons are held down, the temperature setting will change faster. Approximately five seconds after the button has been released, the display will automatically show the actual freezing or BioFresh temperature (known as the “actual setting”).

The altered temperature will adjust slowly to the new value.

BF/BFI 1051 5