Liebherr 7084284-03 Putting into operation, Changing the door hinges, To change the hinges

Putting into operation

u Unscrew the red transport lock. Close the vacated retaining hole using the stopper (60).

uDispose of packaging material (see 4.6) .

Note

u Clean the appliance (see 6.3) .

If the appliance is installed in a very damp environment, condensate may form on the outside of the appliance.

u Always see to good ventilation at the installation site.

4.3 Changing the door hinges

NOTICE*

Risk of damage to side-by-side appliances due to condensa- tion!

When a side-by-side appliance (S…) is fitted together with a second appliance (as a SBS combination), the door hinges must remain as delivered.

u Do not change over the door hinges.

Make sure the following tools are to hand: q Spanner 13

q Cordless screwdriver Torx® 15, 20, 25, 30 Slide the appliance 2/3 of the way into the recess. Pull out the mains plug.

Open the doors.

4.3.1 To detach the soft stop mechanism*

CAUTION

Risk of injury if soft stop contracts! u Detach with care.

Fig. 3 u Push tension spring Fig. 3 (11) outwards, using a screw-

driver.

u Lower soft stop mechanism Fig. 3 (2) for removal. u Unscrew holder Fig. 3 (1).

u Unscrew the ball stud Fig. 3 (3) (Torx® 20).

4.3.2 To change the hinges

Fig. 4

uLift off the covers Fig. 4 (5,6,7,8) forwards using a flat-blade screwdriver.

uLoosen the top and bottom screws Fig. 4 (9) on the appli- ance body, without removing them.

uPull the doors outwards and detach them.

uTransfer the screws Fig. 4 (9) to the opposite side and screw them in a little.

uUndo the screws Fig. 4 (10) and change over the hinges diagonally.

The screws Fig. 4 (10) are self-tapping: use a cordless screw- driver.

u Screw the hinges firmly into place with 4 Nm.

u Place plugs Fig. 4 (12) in the now unused fastening holes. u Attach the doors to the pre-fitted screws Fig. 4 (9) and

tighten the screws firmly with 4 Nm.

4.3.3 Re-fit the soft stop mechanism*

Fig. 5 u Screw the ball stud Fig. 5 (3) firmly into the new fastening

hole with 4 Nm (Torx® 20).

u Push tension spring Fig. 5 (11) inwards again.

u Screw the mount Fig. 5 (1) firmly into place with 3 Nm. u Attach soft stop mechanism Fig. 5 (2) to ball stud.

WARNING

Risk of injury due to the door dropping out!

If the fastening parts are not screwed into place firmly enough, the door may drop out. This may lead to severe injuries. What is more, the door may not close and therefore the appliance may fail to cool properly.

u Screw the hinges and the ball journal of the soft stop mecha- nism firmly into place, with 4 Nm.

u Screw the holder of the soft stop mechanism firmly into place, with at least 3 Nm.

u Check all of the screws and retighten if necessary.

5