Rangemaster 90 Gas manual Installation, Provision of Ventilation, Location of Cooker

Page 24

Installation

You must be aware of the following safety requirements & regulations

Prior to installation, ensure that the local distribution conditions (nature of the gas and gas pressure) and the adjustment of the appliance are compatible.

This appliance shall be installed in accordance with the regulations in force and only in a well ventilated space. Read the instructions before installing or using this appliance.

In the UK the regulations and standards are as follows:-

In your own interest and that of safety, it is law that all gas appliances be installed by competent persons. CORGI registered installers undertake to work to safe and satisfactory standards. Failure to install the appliance correctly could invalidate any warranty or liability claims and lead to prosecution.

This appliance should not be installed in a boat or caravan.

The cooker must be installed in accordance with:-

All relevant British Standards / Codes of Practice, in particular BS 5440 Part 2 2000,

or Natural Gas - BS 6172 : 1990 and BS 6891 : 1998

For LP Gas - BS 5482-1:1994 (when the installation is in a permanent dwelling).

The Gas Safety (Installation and Use) regulations 1998.

The relevant Building / IEE regulations.

Provision of Ventilation

This appliance is not connected to a combustion products evacuation device. Particular attention shall be given to the relevant requirements regarding ventilation.

In the UK

The room containing the cooker should have an air supply in accordance with BS 5440 Part 2 : 2000. All rooms require an openable window or equivalent, while some rooms require a permanent vent in addition to the openable window. The cooker should not be installed in a bedsitting room with volume less than 20m3. If it is installed in a room of volume less than 5m3 an air vent of effective area 100cm2 is required; if it is installed in a room of volume between 5m3 and 10m3, an air vent of effective area 50cm2 is required; while if the volume exceeds 11m3, no air vent is required.

If there are other fuel burning appliances in the same room, BS 5440 Part 2 : 2000 should be consulted to determine the requisite air vent requirements.

Location of Cooker

The cooker may be installed in a kitchen/kitchen diner but NOT in a room containing a bath or shower.

NOTE:

An appliance for use on LPG shall not be installed in a room or internal space below ground level. e.g. in a basement.

All models are supplied set for use on either group H natural gas or for use on LP gas.

They cannot be converted from one gas to the other.

This appliance is designed for domestic cooking only. Use for any other purpose could invalidate any warranty or liability claim.

24

Page 23 Page 25
Image 24
Page 23 Page 25
Contents 90 Gas Users Guide Installation This appliance should not be installed in a boat or caravanBe safe Gas and Electricity onContents Hotplate burners Griddle Grill Natural gasLP Gas Main Gas Oven Main Oven shelves HandyrackMain Oven light ‘S’ Slow cookingTall Oven electric Clock Cooking using the timer Auto is showing, you want to reset to manual cookingClock Special Features Oven cooking Steam to disperseMain Gas Oven cooking guide Tall Fan electric Oven cooking guide Cleaning your cooker Hotplate burnersLH hotplate Wok burnerGriddle Control Panel and DoorsGrill OvensCleaning Table Hotplate Part Finish Recommended Cleaning MethodOutside of cooker Oven and GrillMoving your cooker Tall OvenRemoving the Main Oven Linings Troubleshooting Oven not coming on when turned on manually Oven not coming on when automatic cookingOven temperature getting hotter as the cooker gets older Turn off the power supplyGeneral Safety Instructions If you smell gas0800 111 Don’t smokeThis appliance is heavy, take care when moving it Installation Provision of VentilationLocation of Cooker They cannot be converted from one gas to the otherDear Installer You will also need the following toolsElectric drill Positioning the Cooker Checking the partsUnpacking the Cooker Moving the Cooker LevellingFit the Handles Fitting the splash back optionalFitting a stability bracket Gas ConnectionPressure testing Electrical ConnectionElectrical checks Grill checkMain Oven check Fitting the plinthCustomer care Thank youTo Remove Ignition/light Switch Servicing NotesTo Remove the Control Panel To Remove Side PanelsTo Remove Clock To Remove a ThermostatMain RH oven Tall ovenTo Change Main Oven Burner Assembly To Change Grill BurnerTo Change Grill Electrode To Remove Main Oven BurnerTo Adjust Main Oven Door Catch Keep To Change Main Oven ElectrodeTo Remove Grill Door To Remove Main Oven DoorTo Change Tall Oven Door Magnetic Latch To Change Ignition GeneratorTo Change Fan in Tall Oven To Remove Tall Oven ElementCircuit Diagram Technical Data Page
Top Page Image Contents