Rangemaster 90 Gas manual Dear Installer, You will also need the following tools, Electric drill

Page 25

Dear Installer

Before you start your installation, please complete the details BELOW.

If your customer has a problem relating to your installation they will be able to contact you easily. Thank you

Installer’s Name

Installer’s Company

Installer’s Telephone number

You will need the following equipment to complete the cooker installation satisfactorily

STABILITY BRACKET

If the cooker is to be supplied with gas through a ﬂexible hose, a stability bracket or chain must be ﬁtted.

These are not supplied by with the cooker but are available at most builders merchants.

GAS PRESSURE TESTER

It is important the gas pressure is set correctly

FLEXIBLE GAS HOSE

Must be in accordance with the relevant standards. For LP Gas it should be suitable for LPG, capable of 50mbar pressure, 70°C temperature rise and carry a red stripe, band or label.

A hose is not supplied by with the cooker.

MULTIMETER

(for electrical checks) Make sure the installation is electrially safe.

You will also need the following tools:

1.Electric drill

2.Masonry drill bit & Rawlplugs (only required if ﬁtting the cooker on a stone or concrete ﬂoor)

3.Steel tape measure

4.Cross head screwdrive

5.Flat head screwdriver

6.Spirit level

7.Pencil

8.Adjustable spanner

9.Screws for fitting stability bracket

25

Image 25

Contents 90 Gas Users Guide This appliance should not be installed in a boat or caravan InstallationBe safe Gas and Electricity onContents Hotplate burners Griddle Natural gas GrillLP Gas Main Gas Oven Handyrack Main Oven shelves‘S’ Slow cooking Main Oven lightTall Oven electric Clock Auto is showing, you want to reset to manual cooking Cooking using the timerClock Special Features Steam to disperse Oven cookingMain Gas Oven cooking guide Tall Fan electric Oven cooking guide Hotplate burners Cleaning your cookerLH hotplate Wok burnerControl Panel and Doors GriddleGrill OvensPart Finish Recommended Cleaning Method Cleaning Table HotplateOutside of cooker Oven and GrillTall Oven Moving your cookerRemoving the Main Oven Linings Troubleshooting Oven not coming on when automatic cooking Oven not coming on when turned on manuallyOven temperature getting hotter as the cooker gets older Turn off the power supplyIf you smell gas General Safety Instructions0800 111 Don’t smokeThis appliance is heavy, take care when moving it Provision of Ventilation InstallationLocation of Cooker They cannot be converted from one gas to the otherYou will also need the following tools Dear InstallerElectric drill Checking the parts Positioning the CookerUnpacking the Cooker Levelling Moving the CookerFitting the splash back optional Fit the HandlesFitting a stability bracket Gas ConnectionElectrical Connection Pressure testingElectrical checks Grill checkFitting the plinth Main Oven checkCustomer care Thank youServicing Notes To Remove Ignition/light SwitchTo Remove the Control Panel To Remove Side PanelsTo Remove a Thermostat To Remove ClockMain RH oven Tall ovenTo Change Grill Burner To Change Main Oven Burner AssemblyTo Change Grill Electrode To Remove Main Oven BurnerTo Change Main Oven Electrode To Adjust Main Oven Door Catch KeepTo Remove Grill Door To Remove Main Oven DoorTo Change Ignition Generator To Change Tall Oven Door Magnetic LatchTo Change Fan in Tall Oven To Remove Tall Oven ElementCircuit Diagram Technical Data Page