Rangemaster 90 Gas To Change Main Oven Electrode, To Remove Grill Door, To Remove Main Oven Door

Page 34

WARNING - SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON

Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.

19. To Change Main Oven Electrode

Remove oven burner (see 15). Remove screw and nut securing the electrode to the burner. Pull lead from back of electrode and fit to new electrode. Fit new electrode to burner.

Reassemble in reverse order. Check ignition.

20. To Remove Grill Door

Remove L H side panel (see 3). Remove the plinth (4 screws) and the central vertical cover (5 screws). Remove the two countersunk screws (1 each side) securing the grill hinge arms to the front of the grill chamber.

NOTE: The arms are spring tensioned. Carefully remove the grill door. Retain the gaskets.

Reassemble in reverse order ensuring that the gasket is fitted between the hinge arm and the front of the grill chamber.

21. To Remove Main Oven Door

Open oven door and remove Handyrack (where fitted) by springing one side out of the bracket on the door and sliding the other side free. Support the door and remove the two screws securing the upper hinge and packing to the cooker front. Remove the door from the lower hinge by lifting slightly and moving outwards.

Reassemble in reverse order.

22. To Change Main Oven Door Outer Panel

Move the cooker forward to gain access to the sides.

There are two types of door

Open the oven door slightly and remove the front panel fixing screws from the door top and bottom (A).

Carefully lift off the outer door panel.

Remove door handle from panel by unscrewing 2 retaining nuts. Fit door handle to new panel

Fit panel to door. Reassemble in reverse order.

23. To Change Main Oven Door Latch

Remove outer door panel (see 15). Remove screws ‘B’ holding latch assembly to inner door panel. Fit new catch and reassemble in reverse order.

Check correct door operation.

24. To Change Oven Door Seal

Open oven door. The seal is held in place by small hooks on the rear face. At the corner pull seal diagonally away from the door centre until that hook is released. Proceed to the next hook and release it in a similar way, and so on. Use force if the hooks are stiff, as the old seal will be discarded.

When fitting new seal, position the seal join at the bottom. Hook the new seal in one of the corner holes of the door, and proceed round the door snapping in each hook in turn.

25. To Adjust Main Oven Door Catch Keep

Open oven door, slacken off locknut at base of keep, and screw in or out as required until required fit is obtained. Retighten locking nut.

26. To Remove Fan Oven Inner Back.

Open RH oven door and remove 4 screws and washers securing the inner back to the back of the oven. Carefully lift away the inner back. Reassemble in reverse order making sure that the 4 screws and washers are fully tightened.

27. To Remove Tall Oven Door

Open oven door, support the door and remove the two screws securing the upper hinge and packing to the cooker front. Remove the door from the lower hinge by lifting slightly and moving outwards.

Reassemble in reverse order.

28. To Change Tall Oven Door Outer Panel

Remove oven door see 16. Lay door face down on a suitable surface and remove 2 screws from bottom edge of door and 2 screws from inside face of door.

Remove outer door panel. Remove door handle by unscrewing 2 screws. Remove 2 cross-headed screws holding door handle fixing bracket to door panel. Fit door handle bracket and door handle to new panel.

34

Page 33 Page 35
Image 34
Page 33 Page 35
Contents 90 Gas Users Guide Be safe InstallationThis appliance should not be installed in a boat or caravan Gas and Electricity onContents Hotplate burners Griddle Natural gas GrillLP Gas Main Gas Oven Main Oven shelves HandyrackMain Oven light ‘S’ Slow cookingTall Oven electric Clock Auto is showing, you want to reset to manual cooking Cooking using the timerClock Special Features Oven cooking Steam to disperseMain Gas Oven cooking guide Tall Fan electric Oven cooking guide LH hotplate Cleaning your cookerHotplate burners Wok burnerGrill GriddleControl Panel and Doors OvensOutside of cooker Cleaning Table HotplatePart Finish Recommended Cleaning Method Oven and GrillTall Oven Moving your cookerRemoving the Main Oven Linings Troubleshooting Oven temperature getting hotter as the cooker gets older Oven not coming on when turned on manuallyOven not coming on when automatic cooking Turn off the power supply0800 111 General Safety InstructionsIf you smell gas Don’t smokeThis appliance is heavy, take care when moving it Location of Cooker InstallationProvision of Ventilation They cannot be converted from one gas to the otherYou will also need the following tools Dear InstallerElectric drill Checking the parts Positioning the CookerUnpacking the Cooker Moving the Cooker LevellingFitting a stability bracket Fit the HandlesFitting the splash back optional Gas ConnectionElectrical checks Pressure testingElectrical Connection Grill checkCustomer care Main Oven checkFitting the plinth Thank youTo Remove the Control Panel To Remove Ignition/light SwitchServicing Notes To Remove Side PanelsMain RH oven To Remove ClockTo Remove a Thermostat Tall ovenTo Change Grill Electrode To Change Main Oven Burner AssemblyTo Change Grill Burner To Remove Main Oven BurnerTo Remove Grill Door To Adjust Main Oven Door Catch KeepTo Change Main Oven Electrode To Remove Main Oven DoorTo Change Fan in Tall Oven To Change Tall Oven Door Magnetic LatchTo Change Ignition Generator To Remove Tall Oven ElementCircuit Diagram Technical Data Page
Top Page Image Contents