Installation
UNPACKING THE COOKER
Unpack the components from inside the grill and oven.
Check that the following parts are present: |
|
Grill pan and grid | Top oven/grill shelf heat shield |
Pan supports | Main oven shelves (2) |
Enamelled burner caps (4) | Top oven/grill shelf (1) |
Aluminium burner bodies(4) | Literature |
LEVELLING
Four skid feet are fitted which can be adjusted up or down to level the cooker.
CONVERSION FOR USE ON BUTANE (G30) OR PROPANE (G31)
Each burner requires the injector to be replaced and bypass screws adjusted or replaced as follows:
1.Remove the loose hotplate burner parts.
2.Using a 7mm socket, replace the hotplate injectors as appropriate (see table on previous page).
3.
4.Remove the enamelled baffle at the front of the grill (2 screws).
5.Remove the screw on the right hand side of the burner and gently slide the burner off the injector.
6.Using a 7mm socket, replace the grill injector as appropriate (see table on previous page).
7.
8.Inside the top oven, remove the central screw securing the burner retainer. Slide the retainer to the right slightly and lift away.
9.Lift the burner assembly and place on the floor of the oven to the right of the burner opening.
10.Using a 7mm socket, replace the oven injector as appropriate (see table on previous page).
11.
12.Replace the main oven injector following the same procedure as for the top oven.
13.Carefully pull off the control knobs.
14.Using a narrow flat bladed screwdriver rotate the bypass screws fully clockwise. The main oven thermostat bypass screw is located on the body of the thermostat below the spindle, the top oven thermostat bypass screw is located on the body of the thermostat to the right of the spindle and the hotplate tap bypass screws are located down the centre of the spindle.
15.
16.Secure the
continued...
27