Master Bilt TAF-74 ERC2, TAF-48 ERC2, TAF-27 ERC2 manual Ground Required For Safe Operation

Page 5

WARNING LABELS AND SAFETY INSTRUCTIONS

This symbol is the safety-alert symbol. When you see this symbol on your cabinet or in this manual, be alert to the potential for personal injury or damage to your equipment.

Be sure you understand all safety messages and always follow recommended precautions and safe operating practices.

NOTICE TO EMPLOYERS

You must make sure that everyone who installs, uses or services your cabinet is thoroughly familiar with all safety information and procedures.

Important safety information is presented in this section and throughout this section and throughout the manual. The following signal words are used in the warnings and safety messages:

DANGER: Severe injury or death will occur if you ignore the message.

WARNING: Severe injury or death can occur if you ignore the message.

CAUTION: Minor injury or damage to your cabinet can occur if you ignore the message.

NOTICE: This is important installation, operation or service information. If you ignore the message, you may damage your cabinet.

The warning and safety labels shown throughout this manual are placed on your Master-Bilt Products cabinet at the factory. Follow all warning label instructions. If any warning or safety labels become lost or damaged, call your customer service department at (800) 684-8988 for replacements.

This label is located on top of the electrical control label and on the wiring channel.

CAUTION!

GROUND REQUIRED

FOR SAFE OPERATION

This label is attached to the cabinet power cord on models with a power cord.

5

Image 5
Contents Master-Bilt Products Installation & Operations ManualPage Table of Contents Store Conditions IntroductionGround Required For Safe Operation Installation Instructions PRE-INSTALLATION InstructionsInspection for Shipping Damage MechanicalElectrical ERC 2 Electronic Refrigeration Control Low Temperature Freezers TAF ModelsPress and hold set for 5 seconds. The display will show CLoC Elec Con ALHi Error Codes Display Control StatusTemperature Resistance Ohms Sensor Probe Temperature and ResistanceFinal Check List Sensor ProbeService Instructions Trouble Shooting Guide MASTER-BILT Part Numbers Owner Responsibility Sale and Disposal