Master Bilt TAF-27 ERC2, TAF-48 ERC2, TAF-74 ERC2 manual Electrical

Page 7

3.Rotate your stock so that older stock does not accumulate. This is especially important for ice cream. A "First-In, First-Out" rotation practice will keep the products in good salable condition.

4.Do not place product in the case when it is soft or partially thawed. Also, product should not be put in the case for at least 6 hours after it is started.

5.Stock cases as quickly as possible, exposing only small quantities to store temperatures for short periods of time.

6.When replacing burned out fluorescent tubes, be sure that the electrical power to the lighting circuit is turned off.

ELECTRICAL

WARNING

Before servicing electrical components in the case or the doors or door frames make sure all power to case is off. Always use a qualified technician.

LEG AND CONDENSATE PAN

INSTALLATION FOR TOP MOUNT

CABINETS ONLY

To comply with Sanitation requirements this cabinet must be mounted on casters, legs (6” high min.) or the base must be sealed to the floor. The casters provided with this case screw into the holes from which the shipping bolts were removed.

7

Image 7
Contents Master-Bilt Products Installation & Operations ManualPage Table of Contents Store Conditions IntroductionGround Required For Safe Operation Mechanical PRE-INSTALLATION InstructionsInstallation Instructions Inspection for Shipping DamageElectrical ERC 2 Electronic Refrigeration Control Low Temperature Freezers TAF ModelsPress and hold set for 5 seconds. The display will show CLoC Elec Con ALHi Error Codes Display Control StatusSensor Probe Sensor Probe Temperature and ResistanceTemperature Resistance Ohms Final Check ListService Instructions Trouble Shooting Guide MASTER-BILT Part Numbers Owner Responsibility Sale and Disposal