Smeg P106NL manual Contents, Instructions for safe and proper use 2. Positioning of hob

Page 1
Contents

Contents

1.Instructions for safe and proper use____________________ 19

2.Positioning of hob__________________________________ 20

2.1Attachment to support structure ________________________________________20

3.Electrical connection _______________________________ 22

4.Gas connection ___________________________________ 23

4.1Connection to LPG __________________________________________________24

4.2Ventilation of rooms _________________________________________________24

4.3Discharge of combustion products ______________________________________24

5.Adapting to different types of gas______________________ 25

5.1Removing the hob___________________________________________________25

5.2Regulation for LPG __________________________________________________26

5.3Regulation for natural gas_____________________________________________26

5.4Regulation of primary air______________________________________________27

5.5Reassembling the hob _______________________________________________27

5.6Regulation of minimum for natural gas ___________________________________27

5.7Regulation of minimum for LPG ________________________________________28

5.8Arrangement of burners on hob ________________________________________28

5.9Lubrication of gas taps _______________________________________________28

6.Description of controls ______________________________ 29

6.1Front control panel __________________________________________________29

7.Using the hob _____________________________________ 30

7.1Burner lighting with safety device _______________________________________30

7.2Practical advice for using the burners____________________________________30

7.3Diameter of containers _______________________________________________30

8.Cleaning and maintenance___________________________ 31

8.1Cleaning stainless steel ______________________________________________31

8.2Cleaning of components ______________________________________________31

THESE INSTRUCTIONS ARE VALID ONLY FOR END USER COUNTRIES WHOSE IDENTIFICATION SYMBOLS APPEAR ON THE COVER OF THIS MANUAL.

THIS BUILT-IN HOB IS CLASS 3.

INSTRUCTIONS FOR THE INSTALLER: these are for the qualified technician who must carry out a suitable check of the gas system, install the appliance, set it functioning and carry out an inspection test.

INSTRUCTIONS FOR THE USER: these contain user advice, description of the commands and the correct procedures for cleaning and maintenance of the appliance.

18

Page 1 Page 2
Image 1
Page 1 Page 2
Contents 7. Using the hob Contents8. Cleaning and maintenance 1. Instructions for safe and proper use 2. Positioning of hob1. Instructions for safe and proper use Instructions for safe and proper useTHE MANUFACTURER DECLINES ALL RESPONSIBILITY FOR IMPROPER USE NEVER UNPLUG BY PULLING ON THE CABLE2. Positioning of hob Instructions for the installer2.1 Attachment to support structure Carefully position the insulation gasket supplied on the external perimeter of the hole made in the top surface see figures below and try to make it stick to the entire surface by applying light pressure with your hands. Refer to the distances shown in the figure for the model to be installed, keeping in mind that for both models the long front side has to skim the hole. Secure the hob to the counter with brackets A supplied. Carefully trim any excess from border B of the gasket. The distances in the following drawing refer to the hole on the inner side of the gasket 3. Electrical connection 4. Gas connection 4.2 Ventilation of rooms 4.1 Connection to LPG4.3 Discharge of combustion products 5.1 Removing the hob 5. Adapting to different types of gas5.3 Regulation for natural gas 5.2 Regulation for LPG5.5 Reassembling the hob 5.4 Regulation of primary air5.6 Regulation of minimum for natural gas 5.8 Arrangement of burners on hob 5.7 Regulation of minimum for LPG5.9 Lubrication of gas taps BURNERSInstructions for the user ARRANGEMENT OF BURNERS - Description of symbols6. Description of controls 6.1 Front control panel7.1 Burner lighting with safety device 7. Using the hob7.2 Practical advice for using the burners 7.3 Diameter of containers8.1 Cleaning stainless steel 8. Cleaning and maintenance8.2 Cleaning of components Never use a steam jet to clean the appliance
Top Page Image Contents