Smeg P106 Regulation of minimum for LPG, Arrangement of burners on hob, Lubrication of gas taps

Page 11

5.7Regulation of minimum for LPG

Instructions for the installer

5.7Regulation of minimum for LPG

To regulate the minimum for LPG, completely tighten (clockwise) the screw inside or next to the gas tap pin (depending on the model).

The diameters of the by-passes for each burner are given in table “5.2 Regulation for LPG ”.

After regulation for a gas other than that inspected, replace the label on the casing with one for the new gas. The label is inside the bag that contains the nozzles.

5.8Arrangement of burners on hob

BURNERS

1 Auxiliary

2 Semi rapid

3 Medium rapid

4 Large rapid

5 UR

If the flame of the UR burners have unstable flame (the ring does not ignite or has difficulty igniting), clean the perforated ring carefully to remove any residues deposited in the holes. If the problem persists after this cleaning, contact an authorised service centre.

5.9Lubrication of gas taps

After a while, the gas tap may become hard to turn or lock. If this happens, it has to be cleaned inside and re-greased.

This must be done by a qualified technician.

28

Image 11

Contents 1. Instructions for safe and proper use 2. Positioning of hob Contents7. Using the hob 8. Cleaning and maintenanceNEVER UNPLUG BY PULLING ON THE CABLE Instructions for safe and proper use1. Instructions for safe and proper use THE MANUFACTURER DECLINES ALL RESPONSIBILITY FOR IMPROPER USE2.1 Attachment to support structure Instructions for the installer2. Positioning of hob Carefully position the insulation gasket supplied on the external perimeter of the hole made in the top surface see figures below and try to make it stick to the entire surface by applying light pressure with your hands. Refer to the distances shown in the figure for the model to be installed, keeping in mind that for both models the long front side has to skim the hole. Secure the hob to the counter with brackets A supplied. Carefully trim any excess from border B of the gasket. The distances in the following drawing refer to the hole on the inner side of the gasket 3. Electrical connection 4. Gas connection 4.3 Discharge of combustion products 4.1 Connection to LPG4.2 Ventilation of rooms 5.1 Removing the hob 5. Adapting to different types of gas5.3 Regulation for natural gas 5.2 Regulation for LPG5.6 Regulation of minimum for natural gas 5.4 Regulation of primary air5.5 Reassembling the hob BURNERS 5.7 Regulation of minimum for LPG5.8 Arrangement of burners on hob 5.9 Lubrication of gas taps6.1 Front control panel ARRANGEMENT OF BURNERS - Description of symbolsInstructions for the user 6. Description of controls7.3 Diameter of containers 7. Using the hob7.1 Burner lighting with safety device 7.2 Practical advice for using the burnersNever use a steam jet to clean the appliance 8. Cleaning and maintenance8.1 Cleaning stainless steel 8.2 Cleaning of components