Smeg P106 Instructions for the installer, Positioning of hob, Attachment to support structure

Contents 1. Instructions for safe and proper use 2. Positioning of hob Contents7. Using the hob 8. Cleaning and maintenanceNEVER UNPLUG BY PULLING ON THE CABLE Instructions for safe and proper use1. Instructions for safe and proper use THE MANUFACTURER DECLINES ALL RESPONSIBILITY FOR IMPROPER USEInstructions for the installer 2. Positioning of hob2.1 Attachment to support structure Carefully position the insulation gasket supplied on the external perimeter of the hole made in the top surface see figures below and try to make it stick to the entire surface by applying light pressure with your hands. Refer to the distances shown in the figure for the model to be installed, keeping in mind that for both models the long front side has to skim the hole. Secure the hob to the counter with brackets A supplied. Carefully trim any excess from border B of the gasket. The distances in the following drawing refer to the hole on the inner side of the gasket 3. Electrical connection 4. Gas connection 4.1 Connection to LPG 4.2 Ventilation of rooms4.3 Discharge of combustion products 5.1 Removing the hob 5. Adapting to different types of gas5.3 Regulation for natural gas 5.2 Regulation for LPG5.4 Regulation of primary air 5.5 Reassembling the hob5.6 Regulation of minimum for natural gas BURNERS 5.7 Regulation of minimum for LPG5.8 Arrangement of burners on hob 5.9 Lubrication of gas taps6.1 Front control panel ARRANGEMENT OF BURNERS - Description of symbolsInstructions for the user 6. Description of controls7.3 Diameter of containers 7. Using the hob7.1 Burner lighting with safety device 7.2 Practical advice for using the burnersNever use a steam jet to clean the appliance 8. Cleaning and maintenance8.1 Cleaning stainless steel 8.2 Cleaning of components