Instructions for the user
7. Using the hob
Check that the flame cap crowns, the burner caps and grids are correctly assembled.
Pins A of the flame cap crowns must be inserted in housings B of the burner rings, and pins C on the grids must be blocked in their respective housings on the hob.
7.1Burner lighting with safety device
Each knob shows the burner it is for (the example at the side corresponds to the front left burner).
The appliance is equipped with an electronic lighter. Just press and simultaneously turn the knob anticlockwise to the minimum flame symbol 
until the burner lights. Keep the knob pressed down for about 2 seconds to keep the flame alight and activate the safety device. It may happen that the burner goes out when the knob is released. In this case, repeat the operation, keeping the knob pressed down for a longer time.
If the burners should go out accidentally, after a roughly 20 second interval the safety device intervenes to block gas flow, including when the tap is open.
7.2Practical advice for using the burners
For better burner performance and minimum gas consumption, flat bottomed, even recipients must be used, with covers and proportional in size to the burners (see paragraph “7.3 Diameter of containers ”).
To avoid overcooking or damage to the surface top while cooking, all recipients or griddles must be positioned within the cooking hob perimeter and must be a minimum distance of
7.3Diameter of containers
BURNERS | Ø min. and max. (in cm) | |
1 | Auxiliary | |
2 | Semi rapid | |
3 | Medium rapid | |
4 | Large rapid | |
5 | UR | |
30