Smeg P106NL manual Instructions for the user, Description of controls, Front control panel

Page 12
Instructions for the user

Instructions for the user

6. Description of controls

6.1Front control panel

All of the commands and controls for the hob are found on the front panel.

MODEL 60 CONTROL PANEL

MODEL 70 CONTROL PANEL

MODEL 100 CONTROL PANEL

DESCRIPTION OF THE KNOB

The flame is lit by pressing the knob and simultaneously turning it anticlockwise to the minimum flame symbol 6. Description of controls.

To adjust the flame, turn the knob to the zone between maximum 6.1Front control panel and minimum MODEL 60 CONTROL PANEL.

Turn off the flame by turning the knob to position DESCRIPTION OF THE KNOB.

ARRANGEMENT OF BURNERS – Description of symbols

REAR RIGHT

REAR LEFT

(REAR LEFT ON 100 CM. MOD.)

(REAR RIGHT ON 100 CM. MOD.)

FRONT RIGHT

FRONT LEFT

(FRONT LEFT ON 100 CM. MOD.)

(FRONT RIGHT ON 100 CM. MOD.)

MIDDLE LEFT

MIDDLE RIGHT

MIDDLE

 

29

Image 12
Contents Contents 7. Using the hob8. Cleaning and maintenance 1. Instructions for safe and proper use 2. Positioning of hobInstructions for safe and proper use 1. Instructions for safe and proper useTHE MANUFACTURER DECLINES ALL RESPONSIBILITY FOR IMPROPER USE NEVER UNPLUG BY PULLING ON THE CABLEInstructions for the installer 2. Positioning of hob2.1 Attachment to support structure Carefully position the insulation gasket supplied on the external perimeter of the hole made in the top surface see figures below and try to make it stick to the entire surface by applying light pressure with your hands. Refer to the distances shown in the figure for the model to be installed, keeping in mind that for both models the long front side has to skim the hole. Secure the hob to the counter with brackets A supplied. Carefully trim any excess from border B of the gasket. The distances in the following drawing refer to the hole on the inner side of the gasket 3. Electrical connection 4. Gas connection 4.1 Connection to LPG 4.2 Ventilation of rooms4.3 Discharge of combustion products 5. Adapting to different types of gas 5.1 Removing the hob5.2 Regulation for LPG 5.3 Regulation for natural gas5.4 Regulation of primary air 5.5 Reassembling the hob5.6 Regulation of minimum for natural gas 5.7 Regulation of minimum for LPG 5.8 Arrangement of burners on hob5.9 Lubrication of gas taps BURNERSARRANGEMENT OF BURNERS - Description of symbols Instructions for the user6. Description of controls 6.1 Front control panel7. Using the hob 7.1 Burner lighting with safety device7.2 Practical advice for using the burners 7.3 Diameter of containers8. Cleaning and maintenance 8.1 Cleaning stainless steel8.2 Cleaning of components Never use a steam jet to clean the appliance