Smeg P106NL manual Electrical connection, Instructions for the installer

Contents 7. Using the hob Contents8. Cleaning and maintenance 1. Instructions for safe and proper use 2. Positioning of hob1. Instructions for safe and proper use Instructions for safe and proper useTHE MANUFACTURER DECLINES ALL RESPONSIBILITY FOR IMPROPER USE NEVER UNPLUG BY PULLING ON THE CABLE2.1 Attachment to support structure Instructions for the installer2. Positioning of hob Carefully position the insulation gasket supplied on the external perimeter of the hole made in the top surface see figures below and try to make it stick to the entire surface by applying light pressure with your hands. Refer to the distances shown in the figure for the model to be installed, keeping in mind that for both models the long front side has to skim the hole. Secure the hob to the counter with brackets A supplied. Carefully trim any excess from border B of the gasket. The distances in the following drawing refer to the hole on the inner side of the gasket 3. Electrical connection 4. Gas connection 4.3 Discharge of combustion products 4.1 Connection to LPG4.2 Ventilation of rooms 5.1 Removing the hob 5. Adapting to different types of gas5.3 Regulation for natural gas 5.2 Regulation for LPG5.6 Regulation of minimum for natural gas 5.4 Regulation of primary air5.5 Reassembling the hob 5.8 Arrangement of burners on hob 5.7 Regulation of minimum for LPG5.9 Lubrication of gas taps BURNERSInstructions for the user ARRANGEMENT OF BURNERS - Description of symbols6. Description of controls 6.1 Front control panel7.1 Burner lighting with safety device 7. Using the hob7.2 Practical advice for using the burners 7.3 Diameter of containers8.1 Cleaning stainless steel 8. Cleaning and maintenance8.2 Cleaning of components Never use a steam jet to clean the appliance