Smeg ST1124S-1 instruction manual Troubleshooting, Fault Description

Page 12

E1

E2

E3

E4

E5

E6

User instructions

2. Troubleshooting

The dishwasher is capable of signalling a number of faults through the simultaneous illumination of several indicator lights, with the following meanings:

FAULT

DESCRIPTION

 

 

 

Acquastop failure

 

The anti-flooding system has been activated (for the

 

relevant models only). The system is tripped in case

 

of water leaks. Contact the after-sales service.

Safety level

The system which limits the water level inside the dishwasher has been tripped. Interrupt the program and switch off the dishwasher. Switch the dishwasher back on, program it again and start the washing cycle. If the problem persists, contact the after-sales service.

Water heating malfunction

The water is not heated or the heating parameters are not correct. Repeat the washing program; if the problem persists, contact the after-sales service.

Water temperature monitoring malfunction Interrupt the program and switch off the dishwasher. Switch the dishwasher back on, program it again and start the washing cycle. If the problem persists, contact the after-sales service.

Water intake malfunction

The appliance does not take in water or does not do so correctly. Check that the water connections are correct, the water intake tap is turned on and the filter is not fouled. If the problem persists, contact the after-sales service.

Water pump-out malfunction

The appliance does not pump out the water or does not do so correctly. Check that the drain hose is not kinked or crushed and that the siphon and filter are not fouled. If the problem persists, contact the after- sales service.



Page 11 Page 13
Image 12
Page 11 Page 13
Contents Guide for Using the Dishwasher and the Washing Programs Contents Description of the controls Upper panelSetting the Washing Program and Switching on 1 Option Button1 Option Light Programme Number & Symbol Load Crockery Cutlery Cancelling the Current Program Washing programsTable for Certification Bodies Reference standardSelecting Half Load Wash on some models only Extra ProgramsDelaying the Program 1 Option ButtonAdjusting the Water Softening System Electronic Setting models with displayWater Hardness Table Switch Setting models without display END of Cycle Removing the DishesTroubleshooting Fault DescriptionWater intake system malfunction For Cleaning Dishwashers Contents Safety and operating instructions Uses Other than Those Described AboveNever be Removed Safety instructions Aquastop Models Appliance Installation instructions Installation and hook-upConnecting to the Water Supply Water supply connectionDrain Connection Electrical connection and precautions If the Appliance is Provided with a Plugless Supply CordWhen Cleaning and Maintaining the Appliance Fuse replacementFor Great Britain only This Appliance Must be EarthedUsing the water softening system Operating instructionsUsing the rinse aid and detergent dispensers Adjusting the Rinse AID Dispenser Setting Adding the Rinse AIDAdding the Detergent Products General warnings and recommendations User instructions Using the baskets EN 50242 Standard Loads for Certification BodiesLower Basket Upper Basket Lower Basket Loading the Lower Basket½ Load Cutlery Basket Upper Basket Loading the Upper Basket Adjusting the Upper Basket Pull-out versionPush-button version Cleaning and maintenance Cleaning the Water Intake FilterCleaning the Spray Arms Avoid the use of acidic or abrasive detergentsCleaning the Filter Unit Prolonged DisuseBefore Starting the Dishwasher After Prolonged Disuse If the dishes fail to dry or remain dull, check that 598
Top Page Image Contents