Smeg ST1124S-1 instruction manual Operating instructions, Using the water softening system

Page 24

User instructions

3. Operating instructions

Once the dishwasher has been correctly installed, prepare for use as follows:

Adjust the water softening system;

Add the regenerating salt;

Add the rinse aid and detergent.

3.1Using the water softening system

The amount of scale contained in the water (water hardness index) can cause whitish staining on the dry dishes, which tend to become dull over time. The dishwasher is equipped with an automatic

softening system which uses a specialSALT regenerating salt to reduce the hardness

of the water.

The dishwasher is factory set for water hardness level 3 (average hardness 41-60°dF24-31°dH).

When using water of medium hardness, the regenerating salt container should be refilled after approximately 20 washing cycles. The salt container can hold approximately 1.7 Kg of salt in grains. Some models are equipped with an optical no-salt indicator. In these models, the cap of the salt container contains a green float which descends as the salt concentration in the water drops. When the green float can no longer be seen through the transparent cap, the container must be topped up with regenerating salt. The container is situated at the bottom of the dishwasher. After removing the lower basket, unscrew the salt container cap by turning it anticlockwise and pour in the salt using the funnel supplied with the dishwasher. Before replacing the cap, remove any salt residues from around the opening.

When using the dishwasher for the first time, in addition to the salt it is also necessary to add one litre of water to the container.

Each time the salt container is refilled, make sure that the cap is securely closed. The mixture of water and detergent must never penetrate the salt container, as this would compromise the operation of the regeneration system. In the event of this occurring, the warranty will be invalidated.

Only use regenerating salt specially formulated for domestic dishwashers. If using salt tablets, do not fill the container completely.



Image 24
Contents Guide for Using the Dishwasher and the Washing Programs Contents Description of the controls Upper panelSetting the Washing Program and Switching on 1 Option Button1 Option Light Programme Number & Symbol Load Crockery Cutlery Cancelling the Current Program Washing programsTable for Certification Bodies Reference standardSelecting Half Load Wash on some models only Extra ProgramsDelaying the Program 1 Option ButtonAdjusting the Water Softening System Electronic Setting models with displayWater Hardness Table Switch Setting models without display END of Cycle Removing the DishesTroubleshooting Fault DescriptionWater intake system malfunction For Cleaning Dishwashers Contents Safety and operating instructions Uses Other than Those Described AboveNever be Removed Safety instructions Aquastop Models Appliance Installation instructions Installation and hook-upConnecting to the Water Supply Water supply connectionDrain Connection Electrical connection and precautions If the Appliance is Provided with a Plugless Supply CordWhen Cleaning and Maintaining the Appliance Fuse replacementFor Great Britain only This Appliance Must be EarthedUsing the water softening system Operating instructionsUsing the rinse aid and detergent dispensers Adjusting the Rinse AID Dispenser Setting Adding the Rinse AIDAdding the Detergent Products General warnings and recommendations User instructions Using the baskets EN 50242 Standard Loads for Certification BodiesLower Basket Upper Basket Lower Basket Loading the Lower Basket½ Load Cutlery Basket Upper Basket Loading the Upper Basket Adjusting the Upper Basket Pull-out versionPush-button version Cleaning and maintenance Cleaning the Water Intake FilterCleaning the Spray Arms Avoid the use of acidic or abrasive detergentsCleaning the Filter Unit Prolonged DisuseBefore Starting the Dishwasher After Prolonged Disuse If the dishes fail to dry or remain dull, check that 598