Smeg ST1124S Adjusting the Water Softening System, Electronic Setting models with display

Page 9

User instructions

ADJUSTING THE WATER SOFTENING SYSTEM

Depending on model, the setting may be made electronically or by means of a selector switch.

ELECTRONIC SETTING (models with display)

N.B.: for the setting below to be possible, a washing program other than the soak program must be set.

Press the PROGRAM DELAY button (12) and keep it pressed until the preset value appears followed by a full stop (normally 3.).

Release the button then press it again in succession to display the value required, referring to the table.

The 6 setting levels available will appear in this order: 3., 4., 5., 0., 1., 2..

When the value required appears on the display, release the button; after 5 seconds the system automatically returns to setting of the program delay, and the setting will be made with the chosen value.

N.B.: the display shows the water hardness setting and the program delay. The dot (.) after the number indicates that the water hardness setting is being displayed. If the dot (.) does not appear, the program delay is being displayed.

WATER HARDNESS TABLE

 

WATER HARDNESS

 

 

SETTING

 

 

 

 

German Degrees (°dH)

French Degrees (°dF)

 

 

 

 

 

 

 

 

0

- 5

0

- 9

0.

 

 

 

 

 

 

6 - 11

10

- 19

1.

 

 

 

 

 

 

 

12

- 21

20

- 36

2.

 

 

 

 

 

 

 

22

- 33

37

- 59

3.

 

 

 

 

 

 

 

34

- 45

60

- 79

4.

 

 

 

 

 

 

46

- 53

80 - 107

5.

Contact your local water board for information on the hardness of your water supply.



Image 9
Contents Guide for Using the Dishwasher and the Washing Programs Contents Upper panel Description of the controlsSetting the Washing Program and Switching on 1 Option Button1 Option Light Programme Number & Symbol Load Crockery Cutlery Washing programs Cancelling the Current ProgramTable for Certification Bodies Reference standardExtra Programs Selecting Half Load Wash on some models only1 Option Button Delaying the ProgramAdjusting the Water Softening System Electronic Setting models with displayWater Hardness Table Switch Setting models without display Removing the Dishes END of CycleFault Description TroubleshootingWater intake system malfunction For Cleaning Dishwashers Contents Safety and operating instructions Uses Other than Those Described AboveNever be Removed Safety instructions Aquastop Models Appliance Installation and hook-up Installation instructionsConnecting to the Water Supply Water supply connectionDrain Connection If the Appliance is Provided with a Plugless Supply Cord Electrical connection and precautionsFuse replacement When Cleaning and Maintaining the ApplianceFor Great Britain only This Appliance Must be EarthedOperating instructions Using the water softening systemUsing the rinse aid and detergent dispensers Adding the Rinse AID Adjusting the Rinse AID Dispenser SettingAdding the Detergent Products General warnings and recommendations User instructions Using the baskets EN 50242 Standard Loads for Certification BodiesLower Basket Upper Basket Lower Basket Loading the Lower Basket½ Load Cutlery Basket Upper Basket Loading the Upper Basket Adjusting the Upper Basket Pull-out versionPush-button version Cleaning the Water Intake Filter Cleaning and maintenanceCleaning the Spray Arms Avoid the use of acidic or abrasive detergentsProlonged Disuse Cleaning the Filter UnitBefore Starting the Dishwasher After Prolonged Disuse If the dishes fail to dry or remain dull, check that 598