Smeg ST1124S-1 instruction manual Installation instructions, Installation and hook-up

Page 20

Installation instructions

2. Installation and hook-up

Remove the polystyrene basket retainers.

Position the appliance in the desired place of installation. The back or sides of the dishwasher may be placed up against walls or other furniture units. If the dishwasher is installed near a heat source, fit the special insulating panel to prevent overheating and malfunction of the appliance. To ensure stability, install integrated or built-under dishwashers only under continuous worktops, and screw them to the adjacent units. To facilitate the installation procedure, the intake and drain hoses can be positioned in any direction; make sure that the hoses are not kinked, crushed or pulled too tightly. Make sure to tighten the locking ring-nut once the pipes have been placed in the direction required. A hole at least 8 cm in diameter is required to allow the power supply cable and pipes to pass.

Level the appliance on the floor using its adjustable feet. This operation is essential for ensuring correct operation of the dishwasher.

Building-in a dishwasher underneath a ceramic hob is absolutely forbidden.

A dishwasher can be built-in underneath a conventional hob provided there is no break in the kitchen worktop, and the dishwasher and hob are installed and secured correctly, so that no hazards are generated.

For free-standing models only

-Installing a hob on top of a free-standing dishwasher is absolutely forbidden.

-If the appliance is not built-in and is therefore accessible on one side, the door hinge area must be covered for safety reasons (injury hazard). The covering fixtures are available as an accessory from specialist dealers or the After-Sales Service.

-To build in the dishwasher, the special kit must be purchased from authorised dealers or the After-Sales Service.

Some models are equipped with only one adjustable foot at the rear, which can be adjusted by turning the screw on the lower front part of the appliance.



Page 19 Page 21
Image 20
Page 19 Page 21
Contents Guide for Using the Dishwasher and the Washing Programs Contents Description of the controls Upper panel1 Option Light Setting the Washing Program and Switching on1 Option Button Programme Number & Symbol Load Crockery Cutlery Cancelling the Current Program Washing programsTable for Certification Bodies Reference standardSelecting Half Load Wash on some models only Extra ProgramsDelaying the Program 1 Option ButtonWater Hardness Table Adjusting the Water Softening SystemElectronic Setting models with display Switch Setting models without display END of Cycle Removing the DishesTroubleshooting Fault DescriptionWater intake system malfunction For Cleaning Dishwashers Contents Never be Removed Safety and operating instructionsUses Other than Those Described Above Safety instructions Aquastop Models Appliance Installation instructions Installation and hook-upDrain Connection Connecting to the Water SupplyWater supply connection Electrical connection and precautions If the Appliance is Provided with a Plugless Supply CordWhen Cleaning and Maintaining the Appliance Fuse replacementFor Great Britain only This Appliance Must be EarthedUsing the water softening system Operating instructionsUsing the rinse aid and detergent dispensers Adjusting the Rinse AID Dispenser Setting Adding the Rinse AIDAdding the Detergent Products General warnings and recommendations User instructions Lower Basket Upper Basket Using the basketsEN 50242 Standard Loads for Certification Bodies ½ Load Lower BasketLoading the Lower Basket Cutlery Basket Upper Basket Loading the Upper Basket Push-button version Adjusting the Upper BasketPull-out version Cleaning and maintenance Cleaning the Water Intake FilterCleaning the Spray Arms Avoid the use of acidic or abrasive detergentsCleaning the Filter Unit Prolonged DisuseBefore Starting the Dishwasher After Prolonged Disuse If the dishes fail to dry or remain dull, check that 598
Top Page Image Contents