Smeg ST1124S-1 instruction manual Water intake system malfunction

Page 13

User instructions

E7

E8

E9

FAULT	DESCRIPTION

	Turbine flow-regulator malfunction
	(for the relevant models only)
	The appliance is not able to "measure" the amount of
	water loaded accurately. Interrupt the program and
	switch off the dishwasher. Switch the dishwasher
	back on, program it again and start the washing
	cycle. If the problem persists, contact the after-sales
	service.

Alternate washing system malfunction

Interrupt the program and switch off the dishwasher. Switch the dishwasher back on, program it again and start the washing cycle. If the problem persists, contact the after-sales service.

Water intake system malfunction

Contact the after-sales service.

Light off

Light on

Light flashing

If an alarm occurs the appliance interrupts the program in progress and signals a fault.

•Alarms E1, E2, E3, E4, E8 and E9 interrupt the current program immediately.

•The E5, E6 alarms interrupts the running program once the cause is resolved, it will bring bach the execution of the program.

•The alarm E7 is visualized at the end of the cycle that comes, however, brought to the end since the operation of the dishwasher is not harmed.

To “reset” an alarm is necessary:

•Open and close the door, or turn off and on the machine. At this point is possible to program the dishwasher again.

If the malfunction persists, contact your authorised Service Centre.

Image 13

Contents Guide for Using the Dishwasher and the Washing Programs Contents Upper panel Description of the controls1 Option Button Setting the Washing Program and Switching on1 Option Light Programme Number & Symbol Load Crockery Cutlery Washing programs Cancelling the Current ProgramTable for Certification Bodies Reference standardExtra Programs Selecting Half Load Wash on some models only1 Option Button Delaying the ProgramElectronic Setting models with display Adjusting the Water Softening SystemWater Hardness Table Switch Setting models without display Removing the Dishes END of CycleFault Description TroubleshootingWater intake system malfunction For Cleaning Dishwashers Contents Uses Other than Those Described Above Safety and operating instructionsNever be Removed Safety instructions Aquastop Models Appliance Installation and hook-up Installation instructionsWater supply connection Connecting to the Water SupplyDrain Connection If the Appliance is Provided with a Plugless Supply Cord Electrical connection and precautionsFuse replacement When Cleaning and Maintaining the ApplianceFor Great Britain only This Appliance Must be EarthedOperating instructions Using the water softening systemUsing the rinse aid and detergent dispensers Adding the Rinse AID Adjusting the Rinse AID Dispenser SettingAdding the Detergent Products General warnings and recommendations User instructions EN 50242 Standard Loads for Certification Bodies Using the basketsLower Basket Upper Basket Loading the Lower Basket Lower Basket½ Load Cutlery Basket Upper Basket Loading the Upper Basket Pull-out version Adjusting the Upper BasketPush-button version Cleaning the Water Intake Filter Cleaning and maintenanceCleaning the Spray Arms Avoid the use of acidic or abrasive detergentsProlonged Disuse Cleaning the Filter UnitBefore Starting the Dishwasher After Prolonged Disuse If the dishes fail to dry or remain dull, check that 598