Smeg ST1124S-1 instruction manual Before Starting the Dishwasher After Prolonged Disuse

Page 39

User instructions

BEFORE STARTING THE DISHWASHER AFTER PROLONGED DISUSE:

•Check that there are no deposits of sludge or rust inside the water pipe: if there are, allow the water to run from the water supply tap for a few minutes.

•Plug the power cord back into the socket.

•Reconnect the water intake hose and open the tap again.

TROUBLESHOOTING MINOR PROBLEMS

In some cases it is possible to remedy minor problems by referring to the following instructions:

If the program fails to start, check that:

•the dishwasher is connected to the electrical power supply;

•there is no power failure;

•the water tap is open;

•the dishwasher door is properly closed.

If water remains inside the dishwasher, check that:

•the drain hose is not kinked;

•the drain siphon is not obstructed;

•the dishwasher filters are not clogged.

If the dishes are not being cleaned properly, check that:

•the correct amount of detergent has been added;

•there is regenerating salt inside the special container;

•the dishes are being loaded correctly;

•the selected program is suitable for the dish types and their degree of soiling;

•all the filters are clean and positioned correctly;

•the spray arm nozzles are not obstructed;

•there is no object obstructing the rotation of the spray arms.

Image 39

Contents Guide for Using the Dishwasher and the Washing Programs Contents Upper panel Description of the controlsSetting the Washing Program and Switching on 1 Option Button1 Option Light Programme Number & Symbol Load Crockery Cutlery Reference standard Cancelling the Current ProgramWashing programs Table for Certification BodiesExtra Programs Selecting Half Load Wash on some models only1 Option Button Delaying the ProgramAdjusting the Water Softening System Electronic Setting models with displayWater Hardness Table Switch Setting models without display Removing the Dishes END of CycleFault Description TroubleshootingWater intake system malfunction For Cleaning Dishwashers Contents Safety and operating instructions Uses Other than Those Described AboveNever be Removed Safety instructions Aquastop Models Appliance Installation and hook-up Installation instructionsConnecting to the Water Supply Water supply connectionDrain Connection If the Appliance is Provided with a Plugless Supply Cord Electrical connection and precautionsThis Appliance Must be Earthed When Cleaning and Maintaining the ApplianceFuse replacement For Great Britain onlyOperating instructions Using the water softening systemUsing the rinse aid and detergent dispensers Adding the Rinse AID Adjusting the Rinse AID Dispenser SettingAdding the Detergent Products General warnings and recommendations User instructions Using the baskets EN 50242 Standard Loads for Certification BodiesLower Basket Upper Basket Lower Basket Loading the Lower Basket½ Load Cutlery Basket Upper Basket Loading the Upper Basket Adjusting the Upper Basket Pull-out versionPush-button version Avoid the use of acidic or abrasive detergents Cleaning and maintenanceCleaning the Water Intake Filter Cleaning the Spray ArmsProlonged Disuse Cleaning the Filter UnitBefore Starting the Dishwasher After Prolonged Disuse If the dishes fail to dry or remain dull, check that 598