Smeg CB61VES manual Final Operations, Adjusting the hob burner minimum for bottled gas

Page 13

Instructions for the Installer

4. FINAL OPERATIONS

After changing the nozzles, put the pan stands, the burner caps and flame diffuser rings back in place.

After adjusting for use of a gas other than the gas used for testing the appliance, replace the gas setting label on the appliance with the label for the new gas. The label is supplied in the bag with the nozzles.

4.1 Adjusting the hob burner minimum for town gas and natural gas

Light the burner and turn it to the minimum setting . Remove the gas tap knob and adjust the regulator screw beside the tap rod until an even minimum flame is obtained.

Put the knob back in place and check the stability of the burner flame (the flame must not go out when the knob is turned quickly from the maximum to the minimum setting). Repeat the operation on all the gas taps.

On models equipped with valves, keep the knob pressed down on the minimum setting for a few seconds to keep the flame alight and prime the safety device.

4.2 Adjusting the hob burner minimum for bottled gas

To adjust the minimum level when using bottled gas, the adjuster screw beside the tap rod must be turned fully clockwise.

The diameters of the bypasses for each individual burner are stated in point "3.2/3.3 Burner and Nozzle Data Tables". When the adjustment is complete, re-seal the bypasses with paint or another similar material.

4.3 Adjusting the oven burner minimum

The oven thermostat has a screw for regulating the minimum setting, accessed by removing the thermostat knob.

When the type of gas used changes, the minimum setting must be adjusted as follows:

•Light the oven burner and keep it operating at the highest setting for 10/15 minutes with the door closed and without the hob. Now turn the knob to the minimum temperature setting, remove the knob and use a straight-head screwdriver to adjust.

•When using bottled gas, the adjuster screw must be turned fully clockwise. The diameter of the by-pass is stated in point “3.2/3.3 Burner and Nozzle Data Tables”.

•When using town or natural gas, adjust the screw so that when the thermostat knob is turned from the maximum to the minimum setting, the flame always remains stable and uniform. When the adjustment is complete, re-seal the screw with paint or equivalents. Close the oven door and check that the burner remains on at the minimum setting.

15

Page 12 Page 14
Image 13
Page 12 Page 14
Contents Table of Contents Never Attempt to Repair the Appliance Precautions for Safety and USEChildren AT a Safe Distance Installing the Appliance Instructions for the InstallerRoom ventilation Electrical connectionCombustion gas discharge This nameplate must never be removedGas connection Solution, never with a naked lightConnection with rubber hose Natural and town gas connectionConnection with steel hose for all types of gas Bottled gas connectionChanging the hob nozzles Adapting to Different Types of GASCapacity G30 G31 100 mm Burner and Nozzle Data Tables 50-60 cm ModelsRated Heat Burner Natural GAS G20 20 mbar Capacity Burner and Nozzle Data Tables 90 cm Models Burners Hob burner layoutAdjusting the oven+grill burner primary air flow Adjusting the oven burner for gas oven models onlyChanging the oven + grill burner nozzle Natural GAS NAdjusting the oven burner minimum Adjusting the hob burner minimum for bottled gasFinal Operations Wall fixing on some models only Fitting the rear splash-back on some models onlyPositioning and levelling the appliance HOB Burner Control Knob Description of Front Panel Controls275C Static Electric Oven Function Knob On Some Models only Electric Oven Thermostat Knob On Some Models onlyPractical hints for using the hob burners Using the HOBLighting the hob burners Pan diameters 90 cm Models Pan diameters 60 cm Models50 X 60 XSwitching on the electric plates Switching on the electric plateHow to use the electric plates Precautions and General Advice Using the OvenUsing the gas oven Lighting the burner by handUsing the electric grill Foods Shelf on Runner How to use the grillStorage compartment Using the gas grillGas cylinder compartment for the relevant models only Lighting the gas grill burner by handElectronic Programmer on Some Models only Setting the timeSemiautomatic cooking Automatic cookingAdjusting the buzzer volume TimerEnd of cooking Stopping the buzzerAnalogue Clock on Some Models only Digital Timer on Some Models onlyCleaning enamel Cleaning and MaintenanceCleaning the hob components Door glazing Cleaning the ovenPan stands Burner caps and flame diffuser ringsLubricating the gas oven taps and thermostat Extraordinary MaintenanceChanging the light bulb Removing the door
Top Page Image Contents