OVERLA Y PAN EL INST ALLA TIO N | |
LEVEL THE UN IT | OVERLA Y PAN ELS |
Once the unit is in position, extend the front leveling legs down by turning the legs clockwise and adjust the height. The rear height adjust- ment can be made from the front of the base. Use a 8 mm socket to adjust the rear rollers. Turn the 8 mm hex bolt clockwise to raise the unit or counterclockwise to lower it.
When the unit is leveled properly, or squared off, door and/or drawer adjustments are less likely to be necessary. Refer to the illustration below for location of the rear roller base adjustment.
IMPORTANT NOTE: Be sure to reference leveling of the unit to the floor and not to surrounding cabinetry. This could affect the operation of the unit, such as door closing.
INS TALL TH E KI CKPLA TE
To install, screw the kickplate to brackets attached to the inside surface of each roller base.
IMPORTANT NOTE: The kickplate must be removed for servicing. The floor cannot interfere with removal. Refer to the label mounted on the kickplate support for height clearance.
Reinstall the grille following the instructions on page 8. Turn power back on to the electrical outlet.
If your customer has chosen an overlay design application, make sure that the panels you are about to install match dimensions listed in the Overlay Panel Specifications on page 12.
IMPORTANT NOTE: The overlay panel must fit over the door frame. The weight of each panel assembly cannot exceed 23 kg, 34 kg for Models
Overlay models are shipped without handle hardware. The cabinet manufacturer or designer will need to provide handle hardware to match the overall decorating scheme.
To install overlay panels, first remove the door trim molding. For
You must allow for 3 mm space between the backer board and the decorative panel, so the panel will slide easily into the door frame.
The illustrations below provide a cross section view of the three panel assembly showing place- ment of the door/ drawer/grille trim and a rear view of the three panel assembly with critical dimensions, standard for all models.
Install the handle hardware before inserting the panel. We recommend larger
Slide the panel into the frame on the door. With the panel in position, replace the frame end. Be sure the panel is inserted completely into the channel for proper fit and alignment.
To reinstall the trim molding on
For the drawer on
REAR |
ADJUSTMENT |
FRONT |
LEVELING LEG |
Rear roller base adjustment | Door trim |
Spacer Panel |
| |
3 | Overlay Panel | |
mm | ||
| 6 mm Backer Panel | |
| 8 mm min | |
| 3 mm Door/Drawer/ | |
| 2 mm | Grille Trim |
|
|
Overlay panels— cross |
section
Overlay Panel | Spacer Panel |
| |
~19 | Backer |
mm | Panel |
3 mm | 6 mm |
Overlay
AC CESSO RIE S
Optional acces- sories are available through your
10