Models 427G and 427RG Installation | 27 |
Overlay Door Panel
The screw holes inside the door are hidden under a cover flap on the door gasket. It is necessary to lift the flap to insert the screws. Use as many screws as necessary to hold the door panel in place properly.
IMPORTANT NOTE: After the first three or four mounting screws are in place, but not completely tightened, close the door and check your panel fit. This is the time to make small adjustments. Once you are satisfied with the appear- ance, open the door and apply the remainder of the screws. Check all screws for tightness.
The metal frame on the glass door has numerous mounting holes on each side of the door. This is to accommodate the
If you choose not to use the
The cross section illustration below shows how this hole passes through the door frame. The hole center is on the small locator groove in the front of the frame. A 1/4" (6) diameter hole is made in the front wall of the extrusion and a 13/32" (11) diameter hole through the rest of the frame.
GASKET | 13/32" (11) |
| |
| DIAMETER |
| GLASS |
| 1/4" (6) |
| DIAMETER |
subzero.com
IMPORTANT NOTE: Install screws in all the mounting holes in the door frame. The nature of the door panel with a narrow outer rim and no connecting center member requires the support provided by the glass door.
After the door panel installation is complete, apply the cover patches or plugs provided over the holes on the inside surface of the door.
The wine storage unit door is made with a sealed double wall tempered glass core. The drill must not contact this core when drilling. Be sure the hole is centered on the small groove in the front of the door frame and the drill passes squarely through the frame. If you are inexperienced with drilling, fasten the handle from the rear of the door panel only.
The cover patches or plugs are part of the insulation system on the door of the wine storage unit. Be sure to cover all the holes in the door that were used.
Door frame cross section.