Sub-Zero 424G, 427RG, 427G Flush Inset Panels-Dual Installation, Dual Flush Inset Installations

Model WS-30 Installation 51

subzero.com

Dual Installations

DUAL FLUSH INSET INSTALLATIONS

Installing two models WS-30 or a model WS-30 and built-in unit side by side in a flush inset application will require adjustments to the dimensions of your finished rough opening, panel sizes and panel offsets. It will also require a dual installation kit, available through your authorized Sub-Zero dealer.

Dual installations without a filler strip can only be accom- plished using two units with opposite hinges as shown in illustration A below. The dual installations shown in illus- trations B and C require a filler strip. Illustration A is the only application that will accommodate the dual wide grille.

IMPORTANT NOTE: The application shown in illustration A can only be achieved by installing dual flush inset panels. Failure to install dual flush inset panels will cause the handle side of the panels to collide when closing. In this application a dual installation accessory kit is also required.

Dual flush inset panels and dual installation kits are avail- able through your authorized Sub-Zero dealer. Refer to the illustration and chart for dual flush inset panel specifica- tions.

Flush Inset Panels—Dual Installation

	H
	A
A	A
	H
	A
	W

Model WS-30

DOOR	W	H
Flush Inset Panel	301/2" (775)	693/4" (1772)
Spacer Panel	291/8" (740) 6815/16" (1751)
Backer Panel	293/4" (756)	699/16" (1767)
GRILLE	W	H
Flush Inset Panel	301/2" (775)	91/4" (235)
Spacer Panel	291/8" (740)	85/16" (211)
Backer Panel	293/4" (756)	815/16" (227)
WINDO W	W	H
Cut-Out	23" (584)	621/4" (1581)
		A
Location		33/4" (95)

Grille panel dimensions listed are for a standard 84" (2134) overall height of the unit. For an 83" (2108) overall height, subtract 1" (25) from grille panel height dimensions. For an 88" (2235) overall height, add 4" (102) to height dimensions. Width dimensions do not vary.