REPLACING
Receptacle
\ \ Owns
1. Be sure surface unit controls are OFF.
2.Line up opening In the reflector bowl and
notch In trim ring with the surrace unit receptacle
4.While pushing the surface unit terminal into
the | receptacle, | lift | a little on the edge | of |
the | unit nearest | the | receptacle |
|
5.When the terminal IS pushed Into the re-
ceptacle as far as rt will go. the surface unit WIII frt Into the trim ring
Terminal
ptacle
3.Hold the surface unit as level as possible
with the terminal just started into the receptacle.
Reflector bowls reflect heat back to the utensils on the surface units. They also help catch spills. When they are kept clean, they reflect heat better and look new longer.
If a trim rrng gets discolored, some of the
utensils used may not be flat enough. Or some may be too large for the surface unit In either case, some of the heat that is meant to go into or around a utensil goes down and heats the trim ring. This extra heat can
discolor it.
LIFT-UP COOKTOP fZI-J/
1. Lift the front of the cooktop at the center and swing the support rod up.
2. | Carefull; | lower | the | cooktop | onto | the | |
| support | rod. | Be | sure | the tip | of the | rod fits in |
| the notch | in | the | cooktop. |
|
| |
3.Wipe with warm soapy water. Use soapy
steel wool pad on stubborn spots.
DO NOT let the cookiop bump the upper oven when lifting. DO NOT drop the cooktop. Damage can result.
19