Whirlpool YGR556 manual Electronic Oven Control

ELECTRONIC OVEN CONTROL

1					2			3	4
	ACCUBAKE
								OVEN
								LIGHT
FIRST STEP/
NEXT STEP REVIEW				B	S A	C	E
	STEPS	UNDO						CLOCK
1,2,3,4							TIMER	SET
							TIMER OFF
P R O G R A M M I N G							SET
					START	ST OP
						TIME			STOP
	CONVECT			AUTO	TIME		MIN
C OOL									CANCEL
	BAKE BAKE BROIL		WARM	CLEAN			HR	START

TEMP

H E A T I N G O P T I O N S

T I M I N G O P T I O N S

	14		13	12	11	10	9	8	7	6	5
1.	Sequence Programming	5.	Stop/Cancel			8.	Timer Functions					11.	Auto Clean
2.	Electronic Oven Control Display	6.	Start			9.	Hour/Minute Adjustment					12.	Temperature Adjustment
3.	Oven Light	7.	Clock Set			10.	Timed Cooking/Timed Cooling					13.	Oven Functions
4. ACCUSIMMER™ Pad												14. Cool Function

Display

WARNING

Food Poisoning Hazard

Do not eat food in oven if "PF" shows on the electronic oven control display.

Doing so can result in food poisoning or sickness.

When “PF” shows on the electronic oven control display, a power failure has occurred and food in the oven may not be properly cooled or fully cooked.

In the case of a power failure, do not eat the food in the oven. Press any pad and reset the Clock if needed.

When power is first supplied to the appliance, “PF” and the current time will appear on the display. Press any pad to clear “PF” from the display.

When the oven is not in use, the display shows the time of day.

When performing a timed cook function, the display will show either hours and minutes, or minutes and seconds.

Stop Cancel

The STOP CANCEL pad stops any function except the Clock, Timer and Control Lock.

Clock

This is a 12-hour clock that shows a.m. and p.m.

To Set:

Before setting, make sure the oven and Timer are off.

1.Press CLOCK SET.

2.Press the HR or MIN “up” or “down” arrow pads to set the time of day, including a.m. or p.m.

3.Press CLOCK SET or START.

Tones

Tones are audible signals, indicating the following:

One tone

■Valid pad press

■Oven is preheated (long tone)

■Function has been entered

Start

The START pad begins any oven function. If not pressed within 5 seconds after pressing a function pad, the “START?” indicator light will flash as a reminder. On some models, “START?” will appear on the display.

If not pressed within 5 minutes after pressing a function pad, the oven display will return to the time of day mode and the programmed function will be canceled.

Three tones

■Invalid pad press

Four tones

■End-of-cycle

■Reminder, repeating each minute after the end-of-cycle tones

Reminder Tones: Reminder tones may be turned off. Press and hold STOP TIME for 5 seconds. “rEP OFF” will appear in the display. Repeat to turn reminder tones back on, and “rEP on” will appear in the display.

All Tones: All of the above tones are preset on. All except the end-of-cycle tones can be turned off.

8