Setting the Timer, Timer Recording | Aiwa XR-M150 instruction

SETTING THE TIMER

3 6

4Select the duration for the timer-activated period

with for g, then press ENTER.

The duration for the timer-activated period can be set between 5 and 240 minutes in 5-minute steps.

• VOL/MULTI JOG is also available instead of fand g.

5Prepare the source.

To listen to a CD, load the disc.

To listen to a tape, insert the tape into deck.

To listen to the radio, tune in to a station.

2, 3, 4

VOL/

MULTI JOG

To listen to the equipment connected to AUX/VIDEO jacks,

set the timer of the connected source (with an external timer) and prepare for the play.

1, 2, 3, 4

The unit can be turned on at a specified time every day with the built-in timer.

Preparation

Make sure the clock is set correctly. (See page 14).

1Press TIMER once to display “ 5”, then press

ENTER within 6 seconds.

“5” is displayed and the time flashes.

If you press ENTER after 6 seconds, another operation may start.

2Designate the timer-on time by pressing f or

g, then press ENTER.

To change the timer-on time by 30 minutes, press and hold

for g.

•VOL/MULTI JOG is also available instead of fand g. After you designate the timer-on time, one of the source names flashes on the display.

3Press any of the function buttons (TAPE, TUNER, AUX, CD) or press for gto select a source,

then press ENTER.

The duration for the timer activated period flashes.

•If TUNER is pressed, the band cannot be selected in this step.

•VOL/MULTI JOG is also available instead of fand g. After you select a source, the duration for the timer-activated period flashes on the display.

15 ENGLISH

6Press POWER to turn the unit off after adjusting

the volume and tone.

When the timer-on time is reached, the unit turns on and begins play with the selected source.

The volume level is automatically set to 20 when the power is turned off with the volume level set to 21 or more.

To check the specified time and source

Press TIMER. The timer-on time, the selected source name and the duration for the timer-activated period flash alternately for 6 seconds.

To cancel timer standby mode temporarily

Press TIMER repeatedly until “5” or “” disappears on the display.

To restore the timer standby mode, press TIMER once or twice

to display “5” or “”.

Using the unit while the timer is set

You can use the unit normally after setting the timer.

Before turning off the power, carry out step 5 to prepare the source, and adjust the volume and tone.

•Timer playback and timer recording will not begin unless the power is turned off.

•Connected equipment cannot be turned on and off by the built- in timer of this unit. Use an external timer.

TIMER RECORDING

Timer recording is applicable for TUNER and AUX/VIDEO (with an external timer) sources only.

Press TIMER repeatedly until “ ” appears on the display, then press ENTER within 6 seconds.

Carry out the steps of “SETTING THE TIMER” from step 2 and insert the tape to be recorded on into deck after step 5.

15-18/XR-M150<U>/Eng

10/4/2000, 5:08 PM