TAPE PLAYBACK
BASIC OPERATIONS
PLAYING BACK A TAPE |
Insert a tape. Then press d to start play. |
Playback side of the tape |
PLAYINGCD |
d
TAPE/REV
MODE
s
a
f,g
zPUSH EJECT
MODE
a 
c f,g
s
The tape counter indicates | PLAYBACK | |
the tape running length | ||
C : The front side is being played (forward). | ||
X : The back side is being played (reverse). | ||
To stop play, press s. | TAPE | |
To pause play, press a. To resume play, press again. | ||
To change the playback side, press dDIR/PRESET in play | ||
|
or pause mode.
INSERTING A TAPE
•You can select a reverse mode to playback one or both sides.
•Use Type I (normal) tapes for playback.
Press TAPE/REV MODE and press zPUSH EJECT mark to open the cassette holder
Insert a tape with the exposed side down. Push the cassette holder to close.
To select a reverse mode
Each time TAPE/REV MODE is pressed, the reverse mode changes.
When using the remote control, press MODE.
To play one side only, select p.
To play from front side to back side once only, select [. To play both sides repeatedly, select ].
To fast forward or rewind, press f or g in stop mode. Then press s to stop the tape.
To start play when the power is off (Direct Play Function)
Press TAPE. The power is turned on and play of the inserted tape begins.
To set the tape counter to 0000
Press s in stop mode.
The counter is also set to 0000 when the cassette holder is opened.
En
About cassette tapes
•To prevent accidental erasure, break off the plastic tabs on the cassette tape after recording with a screwdriver or other pointed tool.
To record on the tape again, cover the tab openings with adhesive tape, etc.
•
•Take up any slack in the tape with a pencil or similar tool before use. Slack tape may break or jam in the mechanism.
ENGLISH 10
10 | 10/4/2000, 5:09 PM |