Creda Single Oven manual Installation and Operational Checks

Page 32

INSTALLATION INSTRUCTIONS

INSTALLATION AND OPERATIONAL CHECKS

Note: These checks should only be carried out by a competent person (eg. CORGI registered)

After installation, check for gas soundness. The supply pressure can be checked at the grill injector. Loosen the fastening screw on the left hand side of the grill burner and slide the burner to the right and then off the injector. Ensure that the grill burner is correctly located and the fixing screw tightened on reassembly.

As the door switch prevents the grill burner and oven burner operating at the same time a bypass switch is provided to allow the supply pressure to be checked at the grill injector with the oven burner operating. The switch is located behind the ventilation slots below the door, on the right hand side.

1.Remove the oven door as shown in the cleaning instructions.

2.Measure the supply pressure at the grill injector as above.

3.Turn the oven on at the thermostat, and depress and hold in the bypass switch button while the flame safety device opens to full rate. This can be done by pushing a screwdriver or similar tool through the ventilation slot in front of the bypass switch.

4.Refit the oven door and grill burner.

5.Check that the grill burner ignites correctly and burns with a steady flame. Check for a steady flame on the low setting.

6.Check that, with the main oven set to mark 9, the burner ignites at low rate, and then increases to full rate within 60 seconds. Leave the oven full on with the door closed for 10 minutes, and check that when the control is turned to the ‘Slow Cook’ setting that the flame reduces.

7.Check the operation of the oven timer, oven light(s) & cooling fan.

Instruct the user on operation of the appliance.

32

Page 31 Page 33
Image 32
Page 31 Page 33
Contents Single Ovens Users Instruction & Installation Book Creda Answer Centre 0541 54 64 Contents Introduction For Your Safety AlwaysNever Features Controls Control MarkingsHints on Automatic Cooking Oven Timer OperationAutomatic Cooking Know Your Timer SymbolsTimer Function Buttons ClockfaceSetting the Time of DAY Setting the Minute MinderAuto Cooking Programmes Appropriate oven function Other Notes on Timer Operation Grill PAN & Handle ABCUsing the Grill Young Children should be Kept AwayUsing the Oven Shelf PositioningMain Oven Utensils Main Oven OperationCold Start Cooking Using the ‘SLOW COOK’ Setting Main Oven Cooking Chart Shelf position 1 is the highestYeast Mixtures Cleaning Main Oven and Grill Care and CleaningCredaclean Oven Liners Control Panel / Trims / Inner Door Panel & Glass Replacement of the Oven LampHOW to Clean the Lamp Lens Cleaning the Doors Installation Instructions GAS Safety Installation & USE RegulationsModel Numbers CB01G LocationTechnical Data GeneralInstallation Final InstallationVentilation List of Loose Items560mm 565mm Connecting to GAS Supply DeepElectrical Connection Connect to a 230-240V A.C. Supply onlyInstallation and Operational Checks Problem Check Something WRONG?Page Page Key Contacts
Top Page Image Contents