Creda Single Oven manual Something WRONG?, Problem Check

SOMETHING WRONG?

Before calling a Service Engineer, please check through the following lists.

THERE MAY BE NOTHING WRONG.

Problem		Check
Nothing works.		If the timer display is blank.
		Then it is likely that there is no electricity supply to your oven.
		Check: (i) That the main cooker wall switch is turned on.
		(ii) Check other appliances to see if you have a power
		cut.
		(iii) Check the main circuit breaker for the property.
	Display shows 0.00 AUTO.	The power supply to your oven has possibly been interrupted, but has
		now come back on again. Reset the timer to the correct time of day and
		"Manual" operation using instructions given in the timer section of the
		book.
	Timer display shows " Auto " lit up	To use the ovens or grill the timer must be set to manual mode. See timer
	or flashing.
		instructions.
	Timer display correct but	The appliance incorporates a safety device to shut down the burners in
	appliance will not operate	the event of a fault, to prevent overheating.
		In this case contact your service engineer to have the fault rectified and
		the safety device reset.
	Can not set an “Auto Cook”	Remember that " Cook period " is the actual length of time for which
	programme	the timer will switch the oven(s) on as part of an "Auto cooking "
		programme.
	Draught from beneath control	A gentle flow of air will be blown from beneath the control panel when
	panel.	the appliance is used. If the appliance is still warm, this cooling fan may
		continue to run, or restart itself after all controls have been turned off.
		The fan will stop once the appliance has cooled.
	Cooling fan not operating	If no air is blown from below the control panel when the controls are
		switched on and you have checked through the " Nothing works "
		section above, then the cooling fan may be faulty. In this case you
		should turn off the appliance and contact your service agent to arrange
		for a repair.
	Oven burner not working	Note that the oven burners only operate when the door is closed to
		ensure safe operation and avoid wasting heat. With the door closed the
		oven burner will ignite.
	Slight smell of gas after closing	This is due to the short delay while the burner reignites and will soon
	oven door.	disperse.
	Oven appears to be cooking at too	It may be necessary to turn to a lower setting than shown on the cook-
	high a temperature.	ing chart or recipe as results depend on personal tastes.
		If the oven appears to be cooking at too high a temperature than
		previously, and turning down the thermostat has no effect, then the
		thermostat may be faulty and you should contact your service agent.
	Timer buzzer/bleeper operates	Buzzer / bleeper should stop automatically after two minutes. If not.
	continually
		press minute minder button to silence.

If you have been through the above list and there is still a problem;

Contact Service (see Key Contacts, back page).

33