Whirlpool AKP 801, AKZ 162, AKP 803, AKP 161, AKZ 517 manual Installation, Prepare installation

Page 20

installation

Step 1 : Prepare installation

Do not lift the appliance by the door handle.

Whilst every care is taken to elimi- nate burrs and raw edges from this product,please take care when handling

-we recommend the use of protective gloves during installation.

Please note that the weight of this appliance is approximately 31kg (unpacked). Take care when lifting it into the housing unit - always use an appropriate method of lifting.

Remove the fixing screws from the

polythene bag on the top of the appli- ance, but leave the appliance in the base tray packaging until you are ready to install it.

If this appliance is to be installed near to a corner where the adjacent cabinets run at right angles forward of the appliance, there must be a gap of at least 90 mm between the appliance and the cabinets, to prevent overheating of the cabinets.

Housing dimensions

The appliance is designed to fit into a

standard 600mm wide housing unit with minimum internal dimensions as shown. 590mm is to the underside of the worktop

when the appliance is built under, or to the underside of the panel above, when the appliance is installed into a tall

housing unit.

Image 20
Contents Users Guide & Installation Handbook Contents & Introduction Safety Declaration of ConformityUsing the grill electric Using the grillUsing aluminium foil Cooling fanUsing the TOP Oven electric When using the top ovenTo turn on the top oven PreheatingTop oven baking guide Cooking times Cooking temperaturesTemperature Shelf Approximate cooking time Position To switch on the oven When using the ovenPreheating Fanned oven Conventional ovenSlow cooking Setting or 100C Aluminium foilMain oven baking guide Cooking times & temperatures To help the air circulate freelyDefrosting and cooling in the main oven Defrosting timesConventional temperature ‘A’ Efficiency Oven Gas Mark Conv FannedTraditional fruit cakes Roast turkeyRoasting guide 160C 180C fanned180C 200C conventional Beef LambUsing the CLOCK/programmer-elecif fitted ModeTo select an alarm tone To set the time of daySemi-automatic cooking Fully automatic cookingSemi-automatic cooking Duration method End time methodFully automatic cooking ex- ample Cleaning Appliance without the glass panel correctly fitted Shelf RunnersInstallation Prepare installationQuantity Colour Description For Fixing Installation 70CMBefore you start Method 1 Without housing unitbetween 2 base units Fixing KitMethod 2 Housing unit with internal height less than 710mm Method 3 Housing unit with internal height 710mm or more Installation 90CM Dimensions For 70/90cm appliances Connect to the elec- tricity supplyFor 60cm BI appliance Housing unit 70cm only Secure appliance into60cm ovens 70/90cm ovensAnti-stain trim if fitted Edging strip if fittedCountries of destination Electric ProductsElectrical supply/load 220 240V ~ 50Hz Troubleshooting Guide Customer careAFTER-SALES Service Changing Light Bulbs This operation must be carried out by a qualified technicianPage Page 5019 610