Whirlpool AKZ 162 Installation 70CM, Before you start, Quantity Colour Description For Fixing

Page 21

installation - 70CM

Before you start

Please read the instructions carefully - planning your installation will save you time and effort.

Look at the different ways the appliance can be installed - as shown on the

following pages - and plan the installation to suit your situation.

Leave the appliance in the base tray packaging until you are ready to install it. When you remove the appliance from the base tray packaging, take care not to damage it.

Whilst every care is taken to eliminate burrs and raw edges from this product, please take care when handling - we recommend the use of protective gloves during installation.

Please note that the weight of this appliance is approximately 47kg

(unpacked). Take care when lifting it into the housing unit - always use an appropri- ate method of lifting.

This appliance must be installed only at low level - ie; under a worktop. The

controls have been designed for viewing at a low level, and it should therefore not be installed at high level.

Please note that all dimensions and sizes given are nominal, some variation is to be expected.

If this appliance is to be installed near to a corner where the adjacent cabinets run at right angles forward of the appliance, there must be a gap of at least 90mm between the appliance and the cabinets, to prevent overheating of the cabinets.

Important: Do not modify the outer panels of this appliance in any way.

Fixing screws - The fixing screws are in a polythene bag in the oven pack. Depend- ing on the method of installation, some of the screws may not be needed.

Step 1: Prepare for installation

There are 3 methods of installing the ap- pliance:

Method 1: Into a space between two base units, ie; without a housing unit.

Method 2: Into a housing unit, with an internal height of less than

710mm, which can be modified to ob- tain the required dimensions.

Method 3: Into a housing unit, with an internal height of 710mm or more. If you have a non standard size of cabinet which leaves a gap above or below the appliance, you may be able to buy a trim kit (to fill in the gap) from the supplier of your cabinets.

Quantity

Colour

Description

For Fixing

 

 

 

 

6

Silver

No 8 x 12mm long

Runners to appliance

 

 

Self tapping screw

 

 

 

 

 

12

Black

No 8 x 12mm long

Runners and sidetrims to

 

 

Chipboard screw

cabinet or housing

 

 

 

 

6

Black

No 8 x 25mm long

Appliance to cabinet

 

 

Chipboard screw

 

 

 

 

 

2

Silver

No 8 x 12mm long

Appliance to sidetrims

 

 

Self tapping screw

 

Image 21
Contents Users Guide & Installation Handbook Contents & Introduction Declaration of Conformity SafetyUsing the grill Using the grill electricUsing aluminium foil Cooling fanWhen using the top oven Using the TOP Oven electricTo turn on the top oven PreheatingCooking temperatures Temperature Shelf Approximate cooking time PositionTop oven baking guide Cooking times When using the oven To switch on the ovenPreheating Fanned oven Conventional ovenAluminium foil Slow cooking Setting or 100CTo help the air circulate freely Main oven baking guide Cooking times & temperaturesDefrosting and cooling in the main oven Defrosting timesConv Fanned Conventional temperature ‘A’ Efficiency Oven Gas MarkRoast turkey Traditional fruit cakes160C 180C fanned Roasting guide180C 200C conventional Beef LambMode Using the CLOCK/programmer-elecif fittedTo set the time of day To select an alarm toneFully automatic cooking Semi-automatic cookingEnd time method Semi-automatic cooking Duration methodFully automatic cooking ex- ample Cleaning Shelf Runners Appliance without the glass panel correctly fittedPrepare installation InstallationInstallation 70CM Before you startQuantity Colour Description For Fixing Fixing Kit Method 1 Without housing unitbetween 2 base unitsMethod 2 Housing unit with internal height less than 710mm Method 3 Housing unit with internal height 710mm or more Installation 90CM Dimensions Connect to the elec- tricity supply For 60cm BI applianceFor 70/90cm appliances Secure appliance into Housing unit 70cm only60cm ovens 70/90cm ovensEdging strip if fitted Anti-stain trim if fittedElectric Products Electrical supply/load 220 240V ~ 50HzCountries of destination Customer care Troubleshooting GuideAFTER-SALES Service This operation must be carried out by a qualified technician Changing Light BulbsPage Page 5019 610