Whirlpool AKP 801, AKZ 162, AKP 803, AKP 161, AKZ 517 manual Installation 90CM

Page 25

installation - 90CM

Step 1 : Prepare installation

Do not lift the appliance by the door handle.

Remove the fixing screws from the polythene bag on the top of the appliance, but leave the appliance in the base tray packaging until you are ready to install it. Whilst every care is taken to eliminate burrs and raw edges from this appliance, please take care when handling - we recommend the use of protective gloves during installation.

Please note that the weight of this appliance is approximately 48kg (unpacked). Take care when lifting it into the housing unit - always use an appropriate method of lifting.

Note: When removing the appliance from the base tray packaging care should

be taken to ensure the appliance is not damaged.

Siting the appliance

If this appliance is to be installed near to a corner where the adjacent cabinets run at right angles forward of the appliance, there must be a gap of at least 90mm between the appliance and the cabinets, to prevent overheating of the cabinets. When installed in a typical 600mm deep built in housing unit, the false back should be removed from the housing unit, to provide the necessary depth for installation.

When the false back is removed, it is normally the case that the support shelf for the appliance leaves a gap between

the back edge of the support shelf and the rear wall of approximately 80mm.

If no gap occurs between the back edge of the shelf and the wall behind the unit, you must create a gap of at least 30mm

by shortening the shelf and any other shelf below the appliance.

Cut 12mm from the top of any plinth that may be fitted (see diagram).

Important: Do not modify the outer panels of this appliance in any way.

Image 25
Contents Users Guide & Installation Handbook Contents & Introduction Declaration of Conformity SafetyUsing the grill Using the grill electricUsing aluminium foil Cooling fanWhen using the top oven Using the TOP Oven electricTo turn on the top oven PreheatingTemperature Shelf Approximate cooking time Position Cooking temperaturesTop oven baking guide Cooking times When using the oven To switch on the ovenPreheating Fanned oven Conventional ovenAluminium foil Slow cooking Setting or 100CTo help the air circulate freely Main oven baking guide Cooking times & temperaturesDefrosting and cooling in the main oven Defrosting timesConv Fanned Conventional temperature ‘A’ Efficiency Oven Gas MarkRoast turkey Traditional fruit cakes160C 180C fanned Roasting guide180C 200C conventional Beef LambMode Using the CLOCK/programmer-elecif fittedTo set the time of day To select an alarm toneFully automatic cooking Semi-automatic cookingEnd time method Semi-automatic cooking Duration methodFully automatic cooking ex- ample Cleaning Shelf Runners Appliance without the glass panel correctly fittedPrepare installation InstallationBefore you start Installation 70CMQuantity Colour Description For Fixing Fixing Kit Method 1 Without housing unitbetween 2 base unitsMethod 2 Housing unit with internal height less than 710mm Method 3 Housing unit with internal height 710mm or more Installation 90CM Dimensions For 60cm BI appliance Connect to the elec- tricity supplyFor 70/90cm appliances Secure appliance into Housing unit 70cm only60cm ovens 70/90cm ovensEdging strip if fitted Anti-stain trim if fittedElectrical supply/load 220 240V ~ 50Hz Electric ProductsCountries of destination Customer care Troubleshooting GuideAFTER-SALES Service This operation must be carried out by a qualified technician Changing Light BulbsPage Page 5019 610