MODELS EW5630SS • EW5636SS
Page 6
4.Remove (3) screws holding electronics mounting bracket to hood. Rotate bracket 180 degrees and
5.Remove the grease filter by pulling down the metal latch tab and tilting filter downward to remove.
6.Remove the protective plastic film covering the decorative flue and the hood at this time.
7.Remove the grease filter by pulling down the metal latch tab and tilting filters downward to remove.
8.Align the keyhole slots on the hood with the mounting screws that were partially tightened into the wall framing. Ensure that hood is seated entirely on mounting screws and that hood is level. Then tighten screws completely.
9.Install (2) 4mm x 38mm long screws into the holes inside the hood and tighten them securely.
10.Carefully place glass canopy on top of the hood. Align nuts on glass canopy with holes inside the hood. Attach canopy with (4) .188” x .250” long flat head screws. Tighten screws securely but DO NOT OVERTIGHTEN.
11.Attach filter tray to bottom of hood using (4) .188” x .375” mounting screws.
12.Snap in
13.Reinstall grease filter by aligning rear filter tab with slots in the hood. Pull down the metal latch tab, push filter into position and release. Make sure filter is securely engaged after installation.