Cisco Systems MeetingPlace Video Integration manual About Changing System Configuration Settings

Chapter 4 Configuring and Managing Cisco MeetingPlace Video Integration

About Changing System Configuration Settings

Users of ISDN video endpoints dial in using an ordinary E.164 number, wait for an IVR prompt, then enter the code for the conference they want to attend.

Table 4-1 Video Conferencing Access Information

Parameter	Values	Where Specified
Video Service Code	The service prefix that is assigned	You specified the service prefix when
	to the dedicated MeetingPlace	you installed
	service created on the	Cisco MeetingPlace Video Integration
	Cisco IPVC MCU.	.
	The Video Service Code in	To view the service prefix:
	MeetingTime must match the	In MeetingTime, click the Configure
	MeetingPlace service prefix
		tab, look for the COMPANY
	defined on the Cisco IPVC MCU.
		SPECIFIC INFORMATION
		heading, click Usage Parameters,
		then scroll down in the panel on the
		right to the Video Service Code field.
		This value will be updated
		automatically in MeetingTime if you
		change it on the Cisco IPVC MCU. It
		is best not to make changes after
		meetings are scheduled.
Main video phone	If your Cisco IPVC MCU system	In MeetingTime, click the Configure
number	is configured to support ISDN	tab, look for the SYSTEM
	video endpoints, enter the	CONFIGRATION heading, click
	telephone number those endpoints	Telephony Access, then scroll down in
	used to dial in to the	the panel to the right to the Video
	Cisco IPVC MCU. This is the DID	Information section.
	number assigned to the Cisco
	IPVC PRI Gateway associated
	with your Cisco IPVC MCU.
	For information, see the
	documentation for your Cisco
	IPVC PRI Gateway.
1st alternate video phone	Cisco MeetingPlace does not	In MeetingTime, click the Configure
number	currently use these fields.	tab, look for the SYSTEM
2nd alternate video		CONFIGRATION heading, click
		Telephony Access, then scroll down in
phone number
		the panel to the right to the Video
		Information section.

About Changing System Configuration Settings

Cisco MeetingPlace Video Integration components are configured to work together. Settings in each component enable communication between the components. If you change settings in one component, you must also change the corresponding setting you entered in other components.

Administrator’s Guide for Cisco MeetingPlace Video Integration Release 5.3

4-2 OL-6280-01