Cisco Systems MeetingPlace Video Integration manual Changing Settings in Other Components

Chapter 4 Configuring and Managing Cisco MeetingPlace Video Integration

About Changing System Configuration Settings

If you need to change values that you entered during installation of

Cisco MeetingPlace Video Integration, or change configuration settings in any of the other component parts needed to make the system work, see the following sections.

Changing Values Entered During Installation of

Cisco MeetingPlace Video Integration

When you installed Cisco MeetingPlace Video Integration, you specified settings for the components needed to run Cisco MeetingPlace Video Integration.

To change these settings, perform the following steps:

Step 1 Stop the Cisco MeetingPlace Web Conferencing master service. The Cisco MeetingPlace Video service will automatically stop.

Step 2 In the Windows Control Panel, double-click MeetingPlace Gateways.

Step 3 Click the Video tab.

Step 4 Change any of the following settings:

•Service Code (the service prefix you specified on the Cisco IPVC MCU for MeetingPlace conferences)

•Tracing Level (logging verbosity)

•MCU IP Address

•MCU User Account (this can be an Operator- or Administrator-level account)

•MCU User Password (password for the user account)

•Voice Link E.164

Step 5 Click OK.

Step 6 Restart the Cisco MeetingPlace Web Conferencing master service. The Cisco MeetingPlace Video service will automatically restart.

Changing Settings in Other Components

To change settings in other components that are required for Cisco MeetingPlace Video Integration, such as the Cisco IPVC MCU or Cisco MeetingPlace H.323/SIP IP Gateway, follow these general steps:

Step 1 Plan to make changes during a time when your system is not in use.

Step 2 If changes you make to settings in the Cisco IPVC MCU will reduce the number of conferences or ports available, make sure that there are still enough resources to accommodate conferences that have already been scheduled. See About Video-Conferencing Statistics, page 4-13.

Step 3 Stop the Cisco MeetingPlace Web Conferencing service, which will also stop the Video Integration service.

Step 4 Make the changes in the other components according to the appropriate section in Chapter 3, “Installing Cisco MeetingPlace Video Integration” and the documentation for those components.

Administrator’s Guide for Cisco MeetingPlace Video Integration Release 5.3

OL-6280-01 4-3