4. REMOVE THE FILTERS AND THE GREASE DRIP RAIL(S)
A.Remove tape on filters.
Remove filters from hood and set aside. NOTE: It is recommended to start with the central one.
B.Remove tape on grease drip rail (1).
Lift out grease drip rail and set aside.
NOTE: The
1 |
HD0175 |
5. REMOVE THE PAN
Using a Phillips no. 2 or Robertson no. 2 screwdriver, remove the screws retaining the pan (shaded part on illustration beside) to the hood. Remove the pan and set aside.
RETAINING SCREWS LOCATION
| HD0176 |
|
6. INSTALL WOOD MOUNTING STRIP |
|
|
Measure and mark a level line on wall above cooktop location for the wood |
|
|
mounting strip (see illustration beside and under step 2). Remove wood mounting |
|
|
strip from back of hood. |
|
|
Use #10 - 2’’ flat head screws to secure the mounting strip to the drywall. Make |
|
|
sure to hit the wall studs. |
|
|
CAUTION |
|
|
Due to the weight of this hood, ensure that the wood strip is |
|
|
attached to all of the available studs (2 studs minimum for a 30’’ |
|
|
width hood, more as hood width increases); not into the drywall |
|
|
alone. | HD0174A |
|
| 1. Drywall | 4. Wall anchor location |
| 2. Wood mounting strip | 5. Back of hood outline |
| 3. Flat head screw | 6. Wall studs |
7. INSTALL THE FLUE AND/OR THE FLAT TOP COVER
7.1DUCTED INSTALLATION: A) OPTIONAL DECORATIVE FLUE AEWP SERIES
For a ducted installation, refer to the instructions sheet included with the optional decorative flue.
B)OPTIONAL FLAT TOP COVER ADPWP SERIES
For ducting through back of hood only, install on hood or on the Optional Decorative Flue AEWP Series. Refer to the instructions sheet included with the optional flat top cover.
7.2
NOTE: The Optional Flat Top Cover ADPWP Series can be installed on the
- 7 -