Bakers Pride Oven MT-200 Outer Coverings, Bulb, Heating Element and Motor Fan, 30W Motor

Page 18

Convection Oven	Maintenance

Outer Coverings

Remove the 4 rear fastening screws “C”.

Bulb, Heating Element and Motor Fan

It is necessary to access the inside of the oven, first removing pans, racks and related supports, and then the conveyor.

30W Motor

Remove the fan by following the procedure outlined above, disconnect the motor from the electrical system, loosen the 4 screws and replace the motor. Before re-installing the fan, check that there is no friction between the motor shaft and the ring nut located inside the oven. If there is, loosen the fixing screws of the ring nut and re-tighten them after eliminating the friction and having centered the ring nut on the motor shaft.

Heating Elements

Disconnect the heating element connections outside the oven chamber. Loosen the heating elements from inside the oven chamber and replace them.

16

Image 18

Contents Convection Oven Warranty Information Limited ONE Year WarrantyTable of Contents Safety Precautions Safety Signs and MessagesIntroduction Safety Standards Power Supply Terminal BoardTechnical Data Data PlateControls and Indicators OperationGeneral Instructions for Use Switching Off Start-Up and UseEnvironmental Standards InstallationSafety Standards Transport and UnpackingInstallation Instructions Electrical Connections Convection Oven Installation Protection of the Auxiliary Electrical Circuit Automatic Safety and Control Devices of the OvenOven Chamber Safety Thermostat Protection of the Chamber FanMaintenance Routine MaintenanceOven Chamber Cleaning Cleaning the Door Glass Cleaning the FanTroubleshooting Problem Probable Remedy CauseRepair Procedures Replacement of Motors30W Motor Outer CoveringsBulb, Heating Element and Motor Fan Heating ElementsReplacement of Chamber Light and Glass Gasket Electro-Mechanical ControlsChamber Face Gasket Replacement Parts POS Code BKI # Description Wiring Diagrams Convection Oven Box 80400, Simpsonville, S.C -0400, USA LI0131/0808