Vermont Casting DVR28IN Lighting & Operating Instructions, Lighting Instructions

If you do not follow these instructions exactly, a fire or explosion may result, causing property damage, personal injury and loss of life.

Vermont Castings DVR28 Direct Vent Gas Fireplace

Lighting & Operating Instructions

For Fireplaces equipped with AF4000 Gas Valve

Warning:

For Your Safety, Read the Following Warnings

before Lighting the Appliance

A.This fireplace is equipped with an ignition device which automatically lights the pilot. DO NOT try to light the pilot by hand.

B.BEFORE OPERATING, smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than the air and will settle on the floor.

What to do if you smell gas

•Do not try to light any appliance.

•Do not operate any electrical switch.

•Do not use any phone in your building.

•Immediately call your gas supplier from a neighbor’s phone. Follow the gas suppliers instructions.

•If you cannot contact your gas supplier call the Fire Department

C.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and replace any part of the control system and any gas control that has been under water.

Lighting Instructions

1.	STOP! Read the safety information above before					Spark to Pilot
	continuing.					Pilot Assembly
2.	This appliance is equipped with an ignition device		“S” Connection
	which automatically lights the pilot. DO NOT try to
			Connect to Module
	light the pilot by hand.
3.	Access the gas control by removing the side cover		Pilot Adjustment
	access door on the left side of the unit.
4.	Turn the remote switch, if used, OFF. Turn the		Screw		Pilot Gas Connection
		Inlet Pressure
	wireless remote, if used, OFF.				Side or Back
		Tap
						“I” Connection
5.	Wait five (5) minutes to clear out any gas.					Connect to
	Then smell for gas, including near the floor.					Module
	If you smell gas, STOP. Follow instruction B
	in the safety warnings above. If you do not
	smell gas, go on to the next step.
6.	Close the access door.
7.	If the appliance will not operate, follow the
	instructions TURNING OFF THE GAS TO
	THE APPLIANCE, and call your service		Pilot Internal			Main Valve Internal Solenoid
	technician or gas supplier.			Outlet
			Solenoid			Connection
				Pressure Tap
			Connection			Green & White Wires

Orange & white Wires

Turning Off the Gas to the Appliance

1.Turn the remote switch to the OFF position.

2.Turn OFF all electrical power to the fireplace if service is required.

3.Open the lower access panel.

4.Turn the shut-off valve on the flexible gas line to the OFF position.

1/2” Gas Supply

1/2” NPT x 3/8” Flare

Shut-Off Valve

3/8” Flex Line

(From Valve)

Valve in the “ON” position

20 20012301